Hitachi 50UX57B 60UX57B HOW to SET UP Your NEW Hitachi Projection TV, Antenna, Location, Viewing

Page 6

HOW TO SET UP YOUR NEW HITACHI PROJECTION TV

ANTENNA

Unless your TV is connected to a cable TV system or to a centralized antenna system, a good outdoor color TV antenna is recommended for best performance. However, if you are located in an exceptionally good signal area that is free from interference and multiple image ghosts, an indoor antenna may be sufficient.

LOCATION

Select an area where sunlight or bright indoor illumination will not fall directly on the picture screen. Also, be sure that the location selected allows a free flow of air to and from the perforated back cover of the set.

To avoid cabinet warping, cabinet color changes, and increased chance of set failure, do not place the TV where temperatures can become excessively hot, for example, in direct sunlight or near a heating appliance, etc.

VIEWING

The major benefit of the HITACHI Projection Television is its large viewing screen. To see this large screen at its best, test various locations in the room to find the optimum spot for viewing.

The best picture is seen by sitting directly in front of the TV and about 10 to 18 feet from the screen. Picture brightness decreases as the viewer moves to the left and right of the receiver.

During daylight hours, reflections from outside light may appear on the screen. If so, drapes or screens can be used to reduce the reflection or the TV can be located in a different section of the room.

If the TV’s audio output will be connected to a Hi-Fi system’s external speakers, the best audio performance will be obtained by placing the speakers equidistant from each side of the receiver cabinet and as close as possible to the height of the picture screen center. For best stereo separation, place the external speakers at least four feet from the side of the TV, place the surround speakers to the side or behind the viewing area. Differences in room sizes and acoustical environments will require some experimentation with speaker placement for best performance.

 

 

￿

 

 

￿￿￿￿￿￿￿￿￿￿

 

￿￿￿￿￿

 

 

￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿

￿￿

￿￿

￿￿￿￿￿

￿￿

￿￿￿￿

￿￿￿￿￿

￿￿￿￿￿￿￿￿￿￿

￿￿￿ ￿￿￿ ￿￿￿

￿

 

￿￿

 

 

￿￿￿￿￿￿￿￿￿￿

 

 

 

 

￿￿

￿￿

￿￿￿

￿￿￿

￿￿￿

￿

￿￿

￿￿￿￿￿￿￿￿￿￿￿￿￿

￿

CAUTION: Magnetic fields, such as those of external speakers, may cause the picture to distort if they are placed too close to the television. Move the magnetic field source away from the television until there is no picture distortion.

6

Image 6
Contents ON-SCREEN Display Useful Information IndexPower Source Important Safeguards Safety TipsPicture Cautions Operation of Your TelevisionAccessories Remote Control Battery Installation and ReplacementLocation HOW to SET UP Your NEW Hitachi Projection TVAntenna ViewingHOOK-UP Cables and Connectors Antenna Connections to Rear Jack PanelFront Panel Controls AI Artificial Intelligence sensor Power lightRemote Control sensor Magic FocusFront Panel Jacks and Connections Rear Panel Jacks Way signal splitter Rear Panel ConnectionsTips on Rear Panel Connections Connecting External Audio Amplifier External ConnectionsConnecting External Video Sources Connecting a Monaural Audio VCR or Laserdisc PlayerBefore Operating External Video Source Connecting a Stereo VCR or Stereo Laserdisc Player Optional, see tips onConnecting a Stereo Laserdisc Player or DVD Player to Input Audio System Setup MULTI-PAGE buttons Genius Remote Control CLU-615MPMULTI-PAGE select switch Light buttonSwitch MULTI-PAGE WindowsCable button HOW to USE the Genius Remote to Control Your TVTV button SAT buttonPIP CH button VOLUME, Mute buttonsPICTURE-IN-PICTURE buttons Help buttonHOW to USE the Remote to Control Your TV Single Mode PIP PICTURE-IN-PICTURE PIPPIP button PICTURE-IN-PICTURE Surf Mode PIP Swap buttonMove button Single Freeze Freeze FRZ button With PIP onFreeze FRZ button With PIP OFF Strobe FreezePrecoded VCR buttons Using the Remote to Control VCR FunctionsOperating the precoded function for your VCR Exclusive TV buttonsUsing the Remote to Control Cable BOX/SATELLITE Functions Precoded Cable BOX buttonsPrecoded Satellite BOX buttons Using the Remote to Control Audio Equipment Functions Operating the precoded function for your audio equipmentPrecoded AMP, CD, or Tape buttons AUDIO, CABLE/SATELLITE, and VCR Codes Amplifier Brand CodeUltratec OSD Audio SET UP Menu LanguagePlug & Play Signal Source Reception BandAuto Channel SET Channel Memory Channel List R S O R Clock SETMagic Focus Custom Channel IDVideo ID Family Favorites Menu Family Favorites Operation Child Lock Child LockEvent Prog Auto Link Mode Closed CaptionDisplay ChannelHitachi First Time TourContrast Brightness Color Tint ResetVideo SharpnessUltra AI Artificial Intelligence Advanced SettingsColor Temperature Auto ColorAudio Bass Treble BalancePerfect Volume MTS ModeAuto Noise Cancel Internal SpeakersTheater Theater ModesSRS Wireless Sound Main TV AudioPIP Audio Info Special Event ReminderCalendar Auto Help Care of Your Hitachi Projection TV Your Remote Control Do notReception Problems Ignition NoiseSymptoms Useful InfoInputs Outputs50UX57B 60UX57B Hitachi Home Electronics DivisionQR41081