Hitachi 61SWX01W manual Using the Remote to Control DVD Functions, Precoded DVD Buttons

USING THE REMOTE TO CONTROL DVD FUNCTIONS

Operating the precoded function for your DVD player.

This remote is designed to operate different types of DVD players. You must first program the remote to match the remote system of your DVD player. (refer to page 37 for pre-codes)

1.Turn ON your DVD player.

2.Aim the remote control at the front of your DVD player.

3.Press and release the DVD button to switch to DVD pre-coded mode.

4.Hold down the DVD button on the remote and enter the two digit preset code that matches your DVD player, as shown on page 37. The indicator light will flash 3 times if the code was accepted.

5.Aim the remote at the DVD player and press the POWER button. The remote will turn off your DVD player when the correct two digit preset code is entered. When this occurs, the remote control is programmed for your DVD player. If the DVD player does not turn off, try a different two digit preset code.

6.The remote will now control your DVD player.

NOTES:

1.If your DVD player cannot be operated after performing the above procedures, your DVD player s code has not been precoded into the remote.

2.In the unlikely event that your DVD player cannot be operated after performing the above procedures, please consult your DVD player operating guide.

3.The remote control will remember the codes you have programmed until the batteries are removed from the remote control. After replacing the batteries repeat the entire programming procedure as stated above.

DVD Button

This button allows the remote to control your DVD player by setting it to DVD mode.

PRECODED DVD Buttons

These buttons transmit the chosen precoded DVD codes.

	POWER
TV		VCR		CBL		SAT
		SOURCE WIZARD
DVD		AV1		AV2		AV3
1			2		3
4			5		6
7			8		9
SLEEP			0			LAST CH
TV/PC			HELP	ASPECT		C.S.
INPUT
		MENU		EXIT
VOL		SELECT			CH
SVCS		MUTE	RECALL		SCHD
	VCR	PLUS+
			INFO	GUIDE/TV
PIP		PIP CH			FREEZE
			PIP ACCESS

PIP MODE SWAP

EXCLUSIVE TV Buttons

These buttons are for operating the TV.

PROG TV/VCR SLOW

REC

MY DVD PLAYER CODE IS:

NOTE: Refer to instruction manual of the DVD player for operation of the buttons exclusively for the DVD player.

35