Hitachi 53SWX01W, 61SWX01W manual Power Source

Page 2

IMPORTANT

Follow all warnings and instructions marked on this projection television.

WARNING

RISK OF ELECTRIC SHOCK

DO NOT OPEN

CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK,

DO NOT REMOVE COVER (OR BACK).

NO USER SERVICEABLE PARTS INSIDE.

REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.

The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated dangerous voltage within the product s enclosure that may be of a sufficient magnitude to constitute a risk of electric shock to persons.

The exclamation point within an equilateral triangle, is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance.

WARNING:

TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THIS PROJECTION TELEVISION TO RAIN OR MOISTURE.

NOTE: ¥ There are no user serviceable parts inside the television.

¥Model and serial numbers are indicated on back side of the television.

¥This television is not intended for use in a computer room.

CAUTION: Adjust only those controls that are covered in the instructions, as improper changes or modifications not expressly approved by HITACHI could void the user s warranty.

CAUTION: TO PREVENT ELECTRIC SHOCK, MATCH WIDE BLADE OF PLUG TO WIDE SLOT, FULLY INSERT.

MODIFICATIONS: The FCC requires the user to be notified that any changes or modifications made to this device that are not expressly approved by Hitachi America, Ltd. Home Electronics Division may void the user s warranty.

POWER SOURCE

This projection television is designed to operate on 120 volts 60Hz, AC current. Insert power cord into a 120 volt 60Hz outlet.

TO PREVENT ELECTRIC SHOCK, DO NOT USE THE TELEVISION S (POLARIZED) PLUG WITH AN EXTENSION CORD, RECEPTACLE, OR OTHER OUTLET UNLESS THE BLADES AND GROUND TERMINAL CAN BE FULLY INSERTED TO PREVENT BLADE EXPOSURE.

NEVER CONNECT THE TELEVISION TO 50HZ, DIRECT CURRENT, OR ANYTHING OTHER THAN THE SPECIFIED VOLTAGE.

NOTE: This television receiver will display television closed captioning, ( paragraph 15.119 of the FCC rules.

CC

or ), in accordance with

CAUTION: Never remove the back cover of the television as this can expose you to very high voltages and other hazards. If the television does not operate properly, unplug the television and call your authorized dealer or service shop.

2

Image 2
Contents 53SWX01W 61SWX01W Power Source Your Hitachi Projection Television Safety TipsSafety Points YOU should Know about Picture Cautions Accessories VOLLocation HOW to SET UP Your NEW Hitachi Projection TVAntenna ViewingHOOK-UP Cables and Connectors Antenna Connections to Rear Jack PanelFront Panel Controls AI Artificial Intelligence sensor Power lightRemote Control sensor Magic FocusFront Panel Jacks and Connections Input OutputRear Panel Jacks Monitor OUTOptical Input Component Y-PBPRInputsCoaxial Input Typical FULL-FEATURE Setup Rear Panel ConnectionsConnect After Turning the Power of the TV OFF Rear Speaker Terminal ConnectionsTips on Rear Panel Connections Tips on Rear Panel ConnectionsConnecting External Audio Sources Connecting External Audio AmplifierConnecting External Video Sources VCRStop VCR or Laserdisc Player Hitachi Model or Similar Model See page 15 for tips on Rear Panel Connections Component Y-PBPR Hdtv SET-TOP BOXPR PB CR CB Audio System Setup Required Optional Effect Feature Connection SurroundGenius Remote Control Light ButtonSatellite SAT HOW to USE the Genius Remote to Control Your TVCable CBL Sleep button AV1, AV2, AV3 buttonsChannel selector buttons Last Channel Last CH buttonCommercial Skip C.S. button VOLUME, Mute buttonAspect button Exit buttonPICTURE-IN-PICTURE PIP Single Mode PIPSplit Mode PIP PIP buttonSwap button PICTURE-IN-PICTURE Surf Mode PIPPIP Mode button SingleSingle Freeze Freeze button With PIP onFreeze button With PIP OFF Split FreezePrecoded VCR Buttons Using the Remote to Control VCR FunctionsOperating the precoded function for your VCR Exclusive TV ButtonsCable CBL button Using the Remote to Control Cable BOX FunctionsOperating the precoded function for your cable box Precoded Cable BOX buttonsSatellite SAT button Using the Remote to Control Satellite Receiver FunctionsOperating the precoded function for your satellite receiver Precoded Satellite Receiver buttonsPrecoded DVD Buttons Using the Remote to Control DVD FunctionsOperating the precoded function for your DVD player Using the Remote to Control Additional AUDIO/VIDEO Equipment Precoded AUDIO/VIDEO ButtonsAUDIO/VIDEO Codes DVD BRAND. . . . . . . . . . . . . CodeUltratec OSD Ultratec OSD Thumb Stick SET UPMenu Language ThumbPlug & Play Antenna or Cable Without Cable BOXSignal Source Signal SourceAuto Channel SET Auto Channel SET BeginChannel Memory Channel List Stick Clock SETThumb 480i, 480P, or 720 input signal 1080i input signal Center Mode Static ModePicture Formats Aspect StyleComponent Color Type FillPosition Customize Channel IDVideo ID Family Favorites Menu Family Favorites Operation Parental Control StickEvent Prog Auto Link Mode Closed CaptionDisplay ChannelFirst Time Tour AfterContrast Brightness Color Tint Sharpness Reset VideoUltra AI Artificial Intelligence Advanced SettingsColor Temperature Auto ColorAudio Perfect Volume MTS ModeAuto Noise Cancel LoudnessDynamic Bass OFF, Surround OFF TheaterTheater Modes Dynamic Bass ON, Surround PRO LogicRock Arena Surround Surround OFFStadium Surround Jazz Club SurroundDolby PRO Logic Dolby Digital Input Source Listenting PositionListening Mode Speaker Setup Select specific speaker output, including a subwooferCare of Your Hitachi Projection TV Your Remote Control Do not¥ Ghosts Reception Problems¥ Ignition Noise ¥ SnowSymptoms Useful InfoOutputs ¥ Component Video Y-PB/PRInputs Hitachi Home Electronics DivisionPage QR45522