Hitachi 53SWX01W, 61SWX01W manual Picture Cautions

Page 4

SAFETY TIPS

PROTECTION AND LOCATION OF YOUR TELEVISION

16-1. If an outside antenna is connected to the television, be sure the antenna system is grounded so as to provide some protection against voltage surges and built-up static charges. Section 810 of the National Electrical Code, NFPA No. 70-1975, provides information with respect to proper grounding of the mast and supporting structure, grounding of the lead-in wire to an antenna discharge unit, size of grounding conductors, location of antenna discharge unit

connection to grounding electrode, and requirements for the grounding electrode.

16-2. Note to CATV system installer:

(Only for television with CATV reception). This reminder is provided to call the CATV system installer s attention to Article 820- 40 of the NEC that provides guidelines for proper grounding and, in particular, specifies that the cable ground shall be connected to the grounding system of the building, as close to the point of cable entry as practical.

ANTENNA

LEAD IN

WIRE

GROUND

CLAMP

ANTENNA DISCHARGE UNIT (NEC SECTION 810-20)

ELECTRIC

SERVICE EQUIPMENT

GROUNDING CONDUCTORS (NEC SECTION 810-21)

GROUNDING CONDUCTORS

POWER SERVICE GROUNDING ELECTRODE SYSTEM

(NEC PART 250 PART H)

NEC NATIONAL ELECTRICAL CODE

EXAMPLE OF ANTENNA GROUNDING AS PER NATIONAL ELECTRICAL CODE INSTRUCTIONS.

17.An outside antenna system should not be located in the vicinity of overhead power lines or other electrical lights or power circuits, or where it can fall into such power lines or circuits. When installing an outside antenna system, extreme care should be taken to keep from touching such power lines or circuits as contact with them might be fatal.

18.For added protection for the television during a lightning storm, or when it is unused for long periods of time, unplug it from the wall outlet and disconnect antenna. This will prevent damage due to lightning and power-line surges.

OPERATION OF YOUR TELEVISION

19. This television should be operated only from the type of power source indicated on the marking label. If you are not sure of the type of power supply at your home, consult your dealer or local power company. For televisions designed to operate from battery power, refer to the operating instructions.

20.If the television does not operate normally by following the operating instructions, unplug the television

￿￿￿from the wall outlet and refer

￿￿￿￿￿￿

servicing to

qualified

service

￿￿￿￿￿￿￿

personnel.

Adjust only

those

 

controls that are covered in the instructions as improper adjustment of other controls may result in damage and will often require extensive work by a qualified service technician to restore the television to normal operation.

21.If your television is to remain unused for a period of time, (such as when going on a holiday), turn

￿the television OFF and unplug it from the wall outlet.

IF THE TELEVISION DOES NOT OPERATE PROPERLY

22. If you

are unable to

restore

 

23. Whenever the television is

normal

operation by following

 

damaged or fails, or if there is a

the detailed procedure

in

your

￿￿￿￿￿￿￿

distinct change in performance

operating instructions,

do

not

 

that indicates a need for service,

attempt any further adjustments.

 

unplug the television and have it

Unplug the television and call

 

checked by a qualified service

your dealer or service technician.

 

technician.

24.It is normal for some televisions to make occasional snapping or popping sounds, particularly when being turned on or off. If the snapping or popping is continuous or frequent, unplug the set and consult your dealer or service technician.

￿￿￿￿

￿￿￿

￿￿￿￿￿￿￿

FOR SERVICING AND MODIFICATION

25.Do not use attachments not recommended by the television manufacturer as they may cause hazards.

26.If replacement parts are required, be sure the service technician has used replacement parts specified by the manufacturer that have the same characteristics as the original part. Unauthorized substitutions may result in fire, electric shock, or other hazards.

27.Upon completion of any service or repairs to the television, ask the service technician to perform routine safety checks to determine that the television is in safe operating condition.

￿￿￿

￿￿￿

PICTURE CAUTIONS

Picture Burn Prevention

¥Continuous on-screen displays such as video games, stock market quotations, computer generated graphics, and other fixed (non-moving) patterns can cause permanent damage to projection television receivers. Such PATTERN BURNS constitute misuse and are NOT COVERED by your HITACHI Factory Warranty.

¥When using Picture-in-Picture function, the sub-picture should not be left permanently in one corner of the screen or a PATTERN BURN may develop over a long period of time.

Public Viewing of Copyrighted Material

Public viewing of programs broadcast by TV stations and cable companies, as well as programs from other sources, may require prior authorization from the broadcaster or owner of the video program material.

4

Image 4
Contents 53SWX01W 61SWX01W Power Source Safety Points YOU should Know about Safety TipsYour Hitachi Projection Television Picture Cautions Accessories VOLHOW to SET UP Your NEW Hitachi Projection TV AntennaLocation ViewingHOOK-UP Cables and Connectors Antenna Connections to Rear Jack PanelFront Panel Controls Power light Remote Control sensorAI Artificial Intelligence sensor Magic FocusFront Panel Jacks and Connections Input OutputRear Panel Jacks Monitor OUTCoaxial Input Component Y-PBPRInputsOptical Input Typical FULL-FEATURE Setup Rear Panel ConnectionsConnect After Turning the Power of the TV OFF Rear Speaker Terminal ConnectionsTips on Rear Panel Connections Tips on Rear Panel ConnectionsConnecting External Audio Sources Connecting External Audio AmplifierConnecting External Video Sources VCRStop VCR or Laserdisc Player Hitachi Model or Similar Model See page 15 for tips on Rear Panel Connections Component Y-PBPR Hdtv SET-TOP BOXPR PB CR CB Audio System Setup Required Optional Effect Feature Connection SurroundGenius Remote Control Light ButtonCable CBL HOW to USE the Genius Remote to Control Your TVSatellite SAT AV1, AV2, AV3 buttons Channel selector buttonsSleep button Last Channel Last CH buttonVOLUME, Mute button Aspect buttonCommercial Skip C.S. button Exit buttonSingle Mode PIP Split Mode PIPPICTURE-IN-PICTURE PIP PIP buttonPICTURE-IN-PICTURE Surf Mode PIP PIP Mode buttonSwap button SingleFreeze button With PIP on Freeze button With PIP OFFSingle Freeze Split FreezeUsing the Remote to Control VCR Functions Operating the precoded function for your VCRPrecoded VCR Buttons Exclusive TV ButtonsUsing the Remote to Control Cable BOX Functions Operating the precoded function for your cable boxCable CBL button Precoded Cable BOX buttonsUsing the Remote to Control Satellite Receiver Functions Operating the precoded function for your satellite receiverSatellite SAT button Precoded Satellite Receiver buttonsOperating the precoded function for your DVD player Using the Remote to Control DVD FunctionsPrecoded DVD Buttons Using the Remote to Control Additional AUDIO/VIDEO Equipment Precoded AUDIO/VIDEO ButtonsAUDIO/VIDEO Codes DVD BRAND. . . . . . . . . . . . . CodeUltratec OSD Ultratec OSD SET UP Menu LanguageThumb Stick ThumbPlug & Play Antenna or Cable Without Cable BOXSignal Source Signal SourceAuto Channel SET Auto Channel SET BeginChannel Memory Channel List Thumb Clock SETStick 480i, 480P, or 720 input signal 1080i input signal Center Mode Static ModePicture Formats Aspect StylePosition FillComponent Color Type Customize Channel IDVideo ID Family Favorites Menu Family Favorites Operation Parental Control StickEvent Prog Auto Link Closed Caption DisplayMode ChannelFirst Time Tour AfterContrast Brightness Color Tint Sharpness Reset VideoAdvanced Settings Color TemperatureUltra AI Artificial Intelligence Auto ColorAudio MTS Mode Auto Noise CancelPerfect Volume LoudnessTheater Theater ModesDynamic Bass OFF, Surround OFF Dynamic Bass ON, Surround PRO LogicSurround OFF Stadium SurroundRock Arena Surround Jazz Club SurroundDolby PRO Logic Dolby Digital Input Source Listenting PositionListening Mode Speaker Setup Select specific speaker output, including a subwooferCare of Your Hitachi Projection TV Your Remote Control Do notReception Problems ¥ Ignition Noise¥ Ghosts ¥ SnowSymptoms Useful InfoInputs ¥ Component Video Y-PB/PROutputs Hitachi Home Electronics DivisionPage QR45522