Hitachi 55DMX01WD specifications Last CH

Page 26

HOW TO USE THE GENIUS REMOTE TO CONTROL YOUR TV

CD, TAPE, AMP buttons

When pressed, each of these buttons will blink to indicate the remote is in Audio/Video mode. (see page 35)

CHANNEL selector buttons

CHANNEL selector buttons are used to set FAMILY FAVORITES, CHANNEL MEMORY, etc.

Enter one, two, or three numbers to select channels. Enter “0” first for channels 1 to 9, or simply press the single digit channel you wish to tune then wait a few seconds for the TV to tune. For channels 100 and above, press the “1” button, wait until two dashes appear next to the channel display on your TV, then enter the remaining two numbers using the number buttons.

Channel selection may also be performed by pressing CH up ( ) or down ( ).

You can also use these number buttons to directly access OSD sub-menu’s of your choice. While navigating the On-Screen- Display’s, you will notice that each sub-menu has a number next to it. For example, the SET UP menu has 9 sub-menu’s. Pressing the button while in the SET UP menu will take you directly to the CLOCK SET sub-menu. This makes navigating the menu’s faster and easier.

NOTE: The TV may not receive some channels if you are not in the correct SIGNAL SOURCE mode. (see page 41)

SLEEP button

Press this button to display the sleep timer in the lower left corner of the screen. Every subsequent press of this button will add 15 minutes to this timer, up to a maximum of three hours. Once set, use RECALL when you want to view time remaining. If the SLEEP button is pressed while the timer is set, it will reset to the original condition.

LAST CHANNEL (LAST CH) button

Use this button to select between the last two channels viewed. (Good for watching two sporting events, etc.)

ANT A 10

LAST CH

ANT A 39

ANTENNA button

The ANT button will select between Antenna A and Antenna B each time the button is pressed.

Ant A 10

ANT

Ant B 28

TV/PC button

Press this button to switch between TV, PC1 (PC INPUT 1) and PC2 (PC INPUT 2) modes.

HELP button

Press this button when a menu is displayed to view HELP text, which gives a description of the displayed menu. The HELP text will be displayed every time a MENU is displayed, until this button is pressed again.

ASPECT button

Press this button to quickly change the aspect ratio of the viewable picture in normal, full, fill, and smooth wide. (See page 46 and 47 for more information)

COMMERCIAL SKIP (C.S.) button

Press this button repeatedly to select channel skip time (30~180 seconds) when no menu is displayed and the TV will tune to the last channel viewed when the selected amount of time is up. The user can change stations “SURF” to any station they wish, and after the selected amount of time, the TV will tune back to the original channel.

MENU button

The MENU button will start the On-Screen Display.

26

Image 26
Contents 55DMX01WD Safety Points YOU should Know about Your Hitachi Television Prevention of Pattern Burn Public Viewing of Copyrighted MaterialAccessories Parts NameLocation HOW to SET UP Your NEW Hitachi Dlptm Rear Projection TVAntenna ViewingHOOK-UP Cables and Connectors Antenna Connections to Rear Jack PanelFront Panel Controls Remote Control SensorTemp Indicator Perfect Picture SensorLamp Temp Power Indicator Indication Meaning ActionPower Lamp LEDFront Panel Jacks and Connections Rear Panel Jacks Component Video Y-PBPRINPUT AUDIO/VIDEO Inputs 1Monitor OUT PC Audio InputTips on Rear Panel Connections Tips on Rear Panel ConnectionsTypical FULL-FEATURE Setup Connect After Turning the Power of the TV OFF Rear Speaker Terminal ConnectionsConnecting External Audio Sources To Audio Input Terminal External AmplifierAudio System Setup Rock Arena OFFStadium Jazz ClubBefore Operating External Video Source Connecting External Video SourcesConnecting a Monaural Audio VCR or Laserdisc Player Connecting a Stereo VCR or Stereo Laserdisc Player Connecting AN S-VIDEO VCR or Laserdisc Player See page 12 for tips on Rear Panel Connections Component Y-PBPR Hdtv SET-TOP BOXVideo Coaxial Output Output Genius Remote Control VolchSET-TOP-BOX STB HOW to USE the Genius Remote to Control Your TVCable CBL Last CH VID3 VID1VID2 PICTURE-IN-PICTURE PIP Single Mode PIPSplit Mode PIP PIP buttonSwap button PICTURE-IN-PICTURE Surf Mode PIPPIP Mode button Single SplitSingle Freeze Freeze button With PIP onFreeze button With PIP OFF Split FreezePrecoded VCR Buttons Using the Remote to Control VCR FunctionOperating the precoded function for your VCR Exclusive TV ButtonsCable CBL button Using the Remote to Control Cable BOX FunctionsOperating the precoded function for your cable box Precoded Cable BOX buttonsOperating the precoded function for your satellite receiver SET-TOP-BOX STB buttonPrecoded DVD Buttons Using the Remote to Control DVD FunctionsOperating the precoded function for your DVD player CD, Tape or AMP Buttons Precoded AUDIO/VIDEO ButtonsAUDIO/VIDEO Codes VCR BRAND. . . . . . . . . . . . . . . . . CodeExit Ultratec OSDLamp Time To Quit Ultratec OSD SET UP Menu LanguageSET UP Plug & PlaySignal Source Signal SourceAuto Channel SET Channel Memory Channel List Clock SET Picture Formats Aspect StyleSize FillPosition Component Color TypeLamp Time Lamp Time counts the hours the lamp has operatedCustomize Channel IDVideo ID Family Favorites Menu Family Favorites Operation Parental Control StickEvent Prog Auto Link Mode Closed CaptionDisplay ChannelContrast Brightness Color Tint Sharpness Reset VideoPerfect Picture Advanced SettingsColor Temperature Auto ColorAudio Perfect Volume MTS ModeAuto Noise Cancel LoudnessTheater Theater ModesStadium Surround SurroundSurround OFF Rock Arena SurroundDolby PRO Logic Dolby Digital ThumbInput Source Listenting PositionListening Mode Thumb Thumb Stick StickSpeaker Setup Select specific speaker output, including a subwooferPC Mode Connection and Operation Front Panel Rear Panel Connection to PCPC Mode Specification RGB PC on Screen DisplaySync Audio Cable SUB 15 Pin RGB Cable Optional Auto PC Mode Ultratec OSD AutoAuto Adjust Auto Auto Adjust Are YOU SURE?PHASE0 PhaseClock PositionClock Brightness 50% Data Recall are YOU SURE?Contrast 50% Data RecallBlue Color Balance REDGreen Expansion Real Normal FullBalance AudioEqualizer Lamp Replacement Type Name Dlptm Lamp Assembly Part Number DP00341Spare Lamp Retaining Lamp Cover Screw Two Clips Retaining Handle Lamp Unit Spare Lamp Retaining Screws Lamp Unit Retaining Screws Plug and Play Trademark AcknowledgmentUseful Info Attn Customer RelationsDo not Symptoms Panel Care of Your Hitachi Projection TVScreen Moisture CondensationSpecification FeaturesHitachi Feature Information Digital Micromirror Devicetm SystemASK QR46313