Hitachi 55DMX01WD specifications Indicator Indication Meaning Action, Lamp LED, Temp, Led, Power

FRONT PANEL CONTROLS

POWER Light

This light is on during normal operation.

Light Blinking Slowly (2 seconds): Rear Projection Television lamp is cooling down. It takes 12-15 seconds to warm up and about 2 minutes to cool down.

POWER Button

Press this button to turn the TV on or off.

FRONT INPUT JACKS (for VIDEO: 3 and PC2 AUDIO)

Use these audio/video jacks for a quick hook-up from a camcorder or VCR to instantly view your favorite show or new recording. Press the INPUT button until VIDEO: 3 appears in the top right corner of the TV screen. If you have mono sound, insert the audio cable into the left audio jack. VIDEO: 3 audio input jacks can be used for PC2 audio when a PC is connected to front input VIDEO: 3 jack. When using S-Video cable on the front panel, make sure the arrow ( ) marking on the S-Video cable points to the left, to properly insert the S-Video cable into your television.

PC INPUT 2 (Front)

Use this 15 pin D-Sub input for a “quick” hook up from your PC connection.

TV/PC Button

Press this button to switch from TV, PC INPUT 1 (PC1) and PC INPUT 2 (PC2). Your selection is shown in the top right corner of the screen.

INPUT/EXIT Button

Press this button to select the current antenna source, VIDEO: 1, 2, 3 or alternate antenna source. Your selection is shown in the top right corner of the screen. This button also serves as the EXIT button when in MENU mode.

NOTE: COMPONENT INPUT takes priority over S-VIDEO input, and S-VIDEO input takes priority over VIDEO input.

MENU Button

This button allows you to enter the MENU, making it possible to set TV features to your preference without using the remote. This button also serves as the SELECT button when in menu mode.

VOLUME Level

Press these buttons for your desired sound level. The volume level will be displayed on the TV screen. These buttons also serve as the cursor left ( ) and right ( ) buttons when in MENU mode.

CHANNEL Selector

Press these buttons until the desired channel appears in the top right corner of the TV screen. These buttons also serve as the cursor down ( ) and up ( ) buttons when in MENU mode.

NOTES:
1.	INDICATOR	INDICATION	MEANING	ACTION
		LIGHT ON	NO LAMP LIGHT	Need to exchange if
			or BROKEN LAMP	LAMP still does not light by
	LAMP LED			“Power On” again.
			WRONG LAMP UNIT	Check assembly condition of
		BLINKING
			ASSEMBLY	LAMP UNIT
	TEMP	LIGHT ON	Too Hot inside the
			OPTIC unit
	LED
		BLINKING	COOLING FAN STOPPED	Call Service
		LIGHT ON	NORMAL
	POWER		OPERATION
		SLOWLY BLINKING	COOL DOWN

2. If the LAMP, TEMP, and POWER LED are blinking in the order below, the Rear Projection Television is warming up.

LAMP TEMP POWER

8