Hitachi 55DMX01WD specifications Operating the precoded function for your satellite receiver

USING THE REMOTE TO CONTROL

SET-TOP-BOX/SATELLITE RECEIVER FUNCTIONS

Operating the precoded function for your satellite receiver.

This remote is designed to operate different types of set-top-box/satellite systems. You must first program the remote to match the remote system of your set-top-box/satellite receiver. (refer to page 36)

1.Turn ON your set-top-box/satellite receiver.

2.Aim the remote control at the front of your set-top-box/satellite receiver.

3.Press and release the SET-TOP-BOX (STB) button to switch to set-top-box/satellite pre-coded mode.

4.Hold down the STB button on the remote and enter the two digit preset code that matches your set-top-box/satellite receiver as shown on page 36. The indicator light will flash 3 times if the code was accepted.

5.Aim the remote at the set-top-box/satellite receiver and press the OFF button. The remote will turn off your set-top-box/satellite receiver when the correct two digit preset code is entered. When this occurs, the remote control is programmed for your set-top- box/satellite receiver. If the set-top-box/satellite receiver does not turn off, try a different two digit preset code.

6.The remote will now control your set-top-box/satellite receiver.

NOTES:

1.If your set-top-box/satellite receiver cannot be operated after performing the above procedures, your set-top- box/satellite receiver code has not been precoded into the remote.

2.In the unlikely event that your set-top-box/satellite receiver cannot be operated after performing the above procedures, please consult your set-top-box/satellite receiver operating guide.

3.The remote control will remember the codes you have programmed until the batteries are removed from the remote control. After replacing the batteries repeat the entire programming procedure as stated above.

4.The ANT button will act as the TV/STB button when in STB mode.

SET-TOP-BOX (STB) button

This button allows the remote to control your set-top- box/satellite receiver by setting it to SET-TOP- BOX/SATELLITE mode.

PRECODED SET-TOP-BOX/SATELLITE RECEIVER buttons These buttons transmit the chosen precoded satellite codes.

EXCLUSIVE TV buttons

These buttons are for operating the TV.

ON					OFF
TV	VCR			CBL			STB
	SOURCE WIZARD
DVD	CD			TAPE			AMP
1			2			3
4			5			6
7			8			9
SLEEP			0				LAST CH
TV/PC			HELP		ASPECT
ANT							C.S.
	MENU		EX		IT
VOL		SELECT				CH
	M
SVCS	UT	E	STATUS			SCHD
VCR	PLUS+
			INFO	GUIDE/TV
VID1			VID2		VID3
PIP		PIP CH				FREEZE
			PIP ACCESS
PIP MODE			SWAP
PROG		TV/VCR				SLOW

REC

CLU-5715TSI

MY SET-TOP-BOX/

SATELLITE CODE IS:

NOTE: Refer to instruction manual of the Set-Top-Box/Satellite Receiver for operation of the buttons exclusively for the Set-Top- Box/Satellite Receiver.

33