Hitachi 55DMX01WD specifications Front Panel Jacks and Connections

FRONT PANEL JACKS AND CONNECTIONS

The front panel jacks are provided as a convenience to allow you to easily connect a VCR, PC or camcorder as shown in the following examples:

AUDIO IN	AUDIO IN
VIDEO 3/PC2	VIDEO 3/PC2

S-VIDEO	L/(MONO)	R				S-VIDEO	L/(MONO)	R
VIDEO			INPUT MENU	VOL- VOL+	CH- CH+	VIDEO			INPUT MENU	VOL- VOL+	CH- CH+
		TV/PC	EXIT SELECT					TV/PC	EXIT SELECT
VIDEO 3		PC2				VIDEO 3		PC2

A/V Cable and
S-INPUT Cable
(Optional)		D-SUB 15 Pin
	Audio Cable
		RGB Cable
	(Optional)	(Optional)
S-VIDEO	V L R
	OUTPUT
Back of VCR		PC

AUDIO OUT

Back of PC

	AUDIO IN
	VIDEO 3/PC2
S-VIDEO	L/(MONO)	R
VIDEO			INPUT MENU	VOL- VOL+	CH- CH+
		TV/PC	EXIT SELECT
VIDEO 3		PC2

S-VHS Video Camera Output

NOTE: Completely insert connection cord plugs when connecting to front panel jacks. If you do not, the played back picture may be abnormal. If you have an S-VHS VCR, use the S-INPUT cable in place of the standard video cable. If you have a mono VCR, insert the audio cable into the left audio jack of your TV. INPUT 3 audio can be used for PC INPUT 2 audio when a PC INPUT 2 is connected.

NOTE: Optional adapter for *Apple® Macintosh® computers. If the optional AESP model G301/U Macintosh to VGA® adapter connector is configured and connected between Macintosh video out and the Rear Projection Television video in, the Macintosh is “forced” to boot in 640 x 480/60 Hz or 800 x 600/60 Hz mode (set mode) because the operational adapter correctly manipulates the Macintosh sense pins.

For the optional adapter to work, it’s DIP switch settings should be # 2, 3, 6, 7 = ON and # 1, 4, 5, 8, 9, 10 = OFF.

See below: Example - See Switch Instructions for details.

Mode 5 = 2367 (SVGA 800 x 600/60 Hz configuration) (VGA 640 x480/60 Hz configuration)

Composite Separate Sync

SW1	SW2	SW3	SW4	SW5	SW6	SW7	SW8	SW9	SW10
	ON	ON			ON	ON
OFF			OFF	OFF			OFF	OFF	OFF

ON

2 3 6 7

ONDIP

1 2 3 4 5 6 7 8 9 10

1 4 5 8 910

OFF

9