Using the Remote to Control VCR Functions

Hitachi 50EX01B, 60EX01B manual Using the Remote to Control VCR Functions, Precoded VCR Buttons

USING THE REMOTE TO CONTROL VCR FUNCTIONS

Operating the precoded function for your VCR.

This remote is designed to operate different types of VCRs. You must first program the remote to match the remote system of your VCR. (refer to page 27)

1.Turn ON your VCR.

2.Aim the remote control at the front of your VCR.

3.Press the VCR button to switch to the VCR pre-coded mode.

4.Hold down the VCR button on the remote, enter the two digit preset code that matches your VCR as shown in page 27. The remote will turn off your VCR when the correct two digit preset code is entered. When this occurs, the remote control is programmed for your VCR. If the VCR does not turn off after five seconds, try a different two digit preset code.

5.The remote will now control your VCR.

*If you wish to control a DVD player, you must follow the remote programming procedure shown above. You may use only the VCR button to program these codes, but note that this button may not be used for more than one component.

NOTES:

1.If your VCR cannot be operated after performing the above procedures, your VCR s code has not been precoded into the remote.

2.In the unlikely event that your VCR cannot be operated after performing the above procedures, please consult your VCR operating guide.

3.The remote control will remember the codes you have programmed until the batteries are removed from the remote control. After replacing the batteries repeat the entire programming procedure as stated above.

4.If your VCR does not have a power function, the remote will issue the CHANNEL UP function.

5.The MENU button will act as the VCR MENU button for HITACHI VCRs.

6.The LST-CH button will act as your VCR ENTER button if required.

7.The SLEEP button will act as your VCR 100 button if required.

POWER

TV CABLE VCR

HELP

PIP CH

TV/VCR

PIP SWAP MOVE FRZ

REC	STOP	PAUSE
	STOP
MENU		EXIT
		RECALL
VOL	LST-CH	CH
	LST-CH
	MUTE

LIGHT

VCR Button

This button allows the remote to control your VCR by set- ting it to VCR mode.

PRECODED VCR Buttons

These buttons transmit the chosen precoded VCR codes. For some VCRs, you must press the RECORD button twice to record a program.

EXCLUSIVE TV Buttons

These buttons are for operating the TV.

1 2 3

4 5 6

7 8 9

INPUTSLEEP

CLU-436UI

NOTE: Refer to instruction manual of the VCR for operation of the buttons exclusively for the VCR.