Hitachi 60EX01B, 50EX01B Using the Remote to Control Cable BOX/SATELLITE Functions, Cable Button

USING THE REMOTE TO CONTROL

CABLE BOX/SATELLITE FUNCTIONS

Operating the precoded function for your cable box.

This remote is designed to operate different types of cable boxes. You must first program the remote to match the remote system in your cable box. (refer to page 27)

1.Turn ON your cable box.

2.Aim the remote control at the front of your cable box.

3.Press the CABLE button on the remote to switch to cable mode.

4.Hold down the CABLE button on the remote, enter the two digit preset code that matched your cable box as shown on page 27. The remote will turn off your cable box when the correct two digit preset code is entered. When this occurs, the remote control is programmed for your cable box. If the cable box does not turn off after five seconds, try another two digit preset code.

5.The remote will now control your cable box.

*If you wish to control a Satellite system or Audio equipment, you must follow the remote programming procedure shown above. You may use only the CABLE button to program these codes, but note that this button may not be used for more than one component.

NOTES:

1.If your cable box cannot be operated after performing the above procedures, your cable box code has not been precoded into the remote.

2.In the unlikely event that your cable box cannot be operated after performing the above procedures, please consult your cable box operating guide.

3.The remote control will remember the codes you have programmed until the batteries are removed from the remote control. After replacing the batteries repeat the entire programming procedure as stated above.

4.If your cable box does not have a power function, the remote will issue the CHANNEL UP function.

5.The LST-CH button will act as your audio component s ENTER button if required.

6.The SLEEP button will act as your audio components 100 button if required.

POWER
TV	CABLE	VCR
HELP	PIP CH	TV/VCR
PIP	SWAP MOVE	FRZ

REC	STOP	PAUSE
MENU		EXIT
		RECALL
VOL	LST-CH	CH

MUTE

CABLE Button

This button allows the remote to control your cable box by setting it to cable.

PRECODED CABLE Box Buttons

These buttons transmit the chosen precoded cable codes.

EXCLUSIVE TV buttons

These buttons are for operating the TV.

LIGHT

1 2 3

4 5 6

7 8 9

INPUTSLEEP

0

CLU-436UI

26