Hitachi 60EX01B, 50EX01B HOW to SET UP Your NEW Hitachi Projection TV, Antenna, Location, Viewing

Page 6

HOW TO SET UP YOUR NEW HITACHI PROJECTION TV

ANTENNA

Unless your TV is connected to a cable TV system or to a centralized antenna system, a good outdoor color TV antenna is recommended for best performance. However, if you are located in an exceptionally good signal area that is free from interference and multiple image ghosts, an indoor antenna may be sufficient.

LOCATION

Select an area where sunlight or bright indoor illumination will not fall directly on the picture screen. Also, be sure that the location selected allows a free flow of air to and from the perforated back cover of the set.

To avoid cabinet warping, cabinet color changes, and increased chance of set failure, do not place the TV where temperatures can become excessively hot, for example, in direct sunlight or near a heating appliance, etc.

VIEWING

The major benefit of the HITACHI Projection Television is its large viewing screen. To see this large screen at its best, test various locations in the room to find the optimum spot for viewing.

The best picture is seen by sitting directly in front of the TV and about 10 to 18 feet from the screen. Picture brightness decreases as the viewer moves to the left and right of the receiver.

During daylight hours, reflections from outside light may appear on the screen. If so, drapes or screens can be used to reduce the reflection or the TV can be located in a different section of the room.

If the TV s audio output will be connected to a Hi-Fi system s external speakers, the best audio performance will be obtained by placing the speakers equidistant from each side of the receiver cabinet and as close as possible to the height of the picture screen center. For best stereo separation, place the external speakers at least four feet from the side of the TV, place the surround speakers to the side or behind the viewing area. Differences in room sizes and acoustical environments will require some experimentation with speaker placement for best performance.

 

 

￿

 

 

￿￿￿￿￿￿￿￿￿￿

 

￿￿￿￿￿

 

 

￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿

￿￿

￿￿

￿￿￿￿￿

￿￿

￿￿￿￿

￿￿￿￿￿

￿￿￿￿￿￿￿￿￿￿

￿￿￿ ￿￿￿ ￿￿￿

￿

 

￿￿

 

 

￿￿￿￿￿￿￿￿￿￿

 

 

 

 

￿￿

￿￿

￿￿￿

￿￿￿

￿￿￿

￿

￿￿

￿￿￿￿￿￿￿￿￿￿￿￿￿

￿

CAUTION: Magnetic fields, such as those of external speakers, may cause the picture to distort if they are placed too close to the television. Move the magnetic field source away from the television until there is no picture distortion.

6

Image 6
Contents Genius Important Safeguards First Time USERemote Control Ultratec BIT-MAPPower Source Safety Tips For Your Personal SafetyProtection and Location of Your Television If the Television does not Operate Properly Picture CautionsOperation of Your Television For Servicing and ModificationAccessories Remote Control Battery Installation and ReplacementLocation HOW to SET UP Your NEW Hitachi Projection TVAntenna ViewingHOOK-UP Cables and Connectors Antenna Connections to Rear Jack PanelFront Panel Controls Power light Remote Control sensorAI Artificial Intelligence sensor Monitor OUT Antenna InputAUDIO/VIDEO Inputs 1 Audio to HI-FIOptional, see tips on Connect After Turning the Power of the TV OFF Rear Speaker Terminal ConnectionsConnecting External Audio Amplifier External ConnectionsBefore Operating External Video Source Connecting External Video SourcesConnecting a Monaural Audio VCR or Laserdisc Player Antenna InputConnecting a Stereo VCR or Stereo Laserdisc Player TV Input Terminal VHS V L R Output Back of VCRConnecting a Stereo Laserdisc Player or DVD Player to Input Audio System Setup Surround Required Optional Effect Feature Switch ConnectionPrecoded VCR Buttons Genius Remote Control CLU-436UILight Button TV/VCR ButtonHOW to USE the Genius Remote to Control Your TV PIP CH button VOLUME, Mute buttonsPICTURE-IN-PICTURE buttons Help buttonMENU, Cursor buttons HOW to USE the Remote to Control Your TVEXIT/RECALL button Sleep buttonPICTURE-IN-PICTURE PIP PIP buttonPIP Video PICTURE-IN-PICTURE Swap buttonMove button Freeze FRZ button With PIP on Freeze FRZ button with PIP OFF Quick FreezeVCR Button Using the Remote to Control VCR FunctionsOperating the precoded function for your VCR Precoded VCR ButtonsCable Button Using the Remote to Control Cable BOX/SATELLITE FunctionsOperating the precoded function for your cable box Precoded Cable Box ButtonsCABLE/SATELLITE, VCR, Audio and DVD Codes CLU-436UI Ultratec OSD Theater Menu Language SET UPMenu Language Menu Language EnglishAntenna or Cable Without Cable BOX Plug & PlayPlug & Play YESSignal Source Antenna Signal SourceSignal Source Reception BandAuto Channel SET Auto Channel SETAuto Channel SET Begin ADD Channel MemoryChannel Memory Channel Memory DeleteChannel List Channel ListChannel List Scan Lock Clock SET Clock SETConvergence Adjust MenuChannel ID CustomChannel ID Channel ID Channel ListVideo ID Video IDVideo ID VID Video ListFamily Favorites Menu Family FavoritesFamily Favorites Operation Family Favorites MoviesEnter Secret Code Parental ControlParental Control ChannelEvent Prog Event ProgramOnce Auto Link Auto LinkMode Closed CaptionDisplay ChannelPower First Time TourFirst Time Tour OFF Contrast Brightness Color Tint ResetVideo SharpnessUltra AI Artificial Intelligence Advanced SettingsColor Temperature Auto ColorTreble AudioBass BalancePerfect Volume MTS ModeAuto Noise Cancel Internal SpeakersTheater Modes TheaterTheater Modes SportsSpecial R S O R Special Event Reminder InfoSpecial Event Reminder Special Event ReminderCalendar L E N D a RCalendar Care of Your Hitachi Projection TV Your Remote Control Do notReception Problems ¥ Ignition NoiseSymptoms Useful InfoOutputs SpecificationsInputs 60EX01B 50EX01BHitachi Home Electronics DivisionPage QR43664