Hitachi 57T600 important safety instructions AV Network Setup Wizard, Back Next

FIRST TIME USE

AV NETWORK SETUP WIZARD

5.Follow the steps below to setup your AV network (See page 23 for AV Network Codes).

There are six steps in the setup procedure (VCR setup example below).

HITACHI AV NET Wizard (step 1 of 6)			HITACHI AV NET Wizard (step 2 of 6)
This Wizard helps you with			Follow the digrams shown in Hitachi’s
VCR connections and settings.				Easy Graphic Guide
Would you like to setup or				to connect your VCR.
	modify your VCR?		Carefully position the IR “mouse” in front
			of your VCR as shown in the diagrams.
	BACK	NEXT		BACK	NEXT

HITACHI AV NET Wizard (step 3 of 6)

Find your VCR

4-digit manufacturers code

and enter it here - - - -

(Enter Code “9999” to uninstall)

BACK		NEXT
	Proper Code Entered
		from page 23.

HITACHI AV NET Wizard (step 4a of 6)

	Which TV Rear Panel Input
	is connected to your VCR?
(	) ANT A		(	) INPUT 3
(	) ANT B		(	) INPUT 4
(	) INPUT 1		(	) INPUT 5
(	) INPUT 2
		BACK	NEXT

INPUTS

HITACHI AV NET Wizard (step 5 of 6)

Turn ON your VCR then press

each of the 3 function keys below.

Your VCR should respond to one of these

keys. Now press NEXT to continue.

POWER		PLAY		CH UP
	BACK		NEXT

HITACHI AV NET Wizard (step 6 of 6)

Did your VCR respond to

POWER, PLAY or CH UP?

Press DONE to finish this wizard or

HELP to trouble shoot settings.

HELP DONE

HELP

TROUBLE SHOOTING

Please check connections shown in the EASY GRAPHIC GUIDE.

If connections are correct,

try a different manufacturers code

for your VCR	0 4 3 6
BACK	NEXT

				ATTENTION
	The 4-digit code did not match
If Error	AV Net’s library. Please check
	and re-enter a valid code						- - - -
			BACK			NEXT
	HITACHI AV NET Wizard (step 4b of 6)
	Which RF channel does your VCR
	use to send video to the TV?
ANT A/B	(			) Channel 03
	(			) Channel 04
		BACK			NEXT

	HITACHI AV NET Wizard
	Congratulations!
DONE	Your VCR is now conected
	to your AV network.

From Step 3, once you enter “9999”, the following message appears.

HITACHI AV NET Wizard (step 3b of 6)

This will uninstall VCR on INPUT 1.

Would you like to proceed?

BACK YES

6.Enter “9999” to uninstall the equipment from your AV Network.

7.See Remote Control AV NET button usage on page 27.

NOTES: 1. If your equipment cannot be operated after performing the above procedures, your equipment code has not been pre- coded into the AV Net.

2.In the unlikely event that your equipment receiver cannot be operated after performing the above procedures, please consult your equipment receiver operating guide.

22