Hitachi 57T600 important safety instructions Rear Panel Jacks, Monitor OUT

REAR PANEL JACKS

ANT A
			DVI-HDTV
		PR	PB	Y	OPTICAL OUT
	INPUT 1				Digital Audio
TO		R	(MONO)/L		IEEE1394
CONVERTER				AUDIO
		PR	PB	Y/VIDEO
	INPUT 2				Multi Media Card
ANT B		R	(MONO)/L
				AUDIO
		R	(MONO)/L	VIDEO	S-VIDEO
	INPUT 3
AUDIO
TO HI-FI
CENTER		R	(MONO)/L	VIDEO	S-VIDEO
	INPUT 4
IN					ANT C
IR					(DTV)
BLASTER		R	L	VIDEO	S-VIDEO
L	MONITOR
	OUT
			AUDIO
R

FIRST TIME USE

Antenna Input/Output

ANT A- A 75-Ohm RF antenna or CATV (Cable TV) input. ANT A can be displayed as a main picture or sub-picture.

ANT B- A 75-Ohm RF antenna or CATV (Cable TV) input. ANT B can only be displayed as a main picture. ANT B cannot be displayed as a sub-picture.

TO CONVERTER- This antenna output allows the ANT A connection to pass directly to a different source, such as a cable box, only when ANT B is displayed as a main picture.

ANT C- A 75-Ohm RF antenna or un-encrypted digital CATV (Cable TV) input. ANT C can be displayed as a main picture or sub- picture. ANT C is used to receive digital broadcast signals. To watch any channel from ANT C, run Auto Channel Scan first (see page 65).

NOTES: 1. You may ask your local cable company whether DTV services are available.

2.When in ANT C, only channels stored in Channel Manager during Auto Channel Scan can be tuned using the number buttons on the remote control (see pages 54-55 and 65).

Audio/Video Inputs 1, 2, 3 and 4

The VID1~VID4 buttons will select each video source each time they are pressed. Use the audio and video inputs to connect external devices, such as VCRs, camcorders, laserdisc players, DVD players etc. (If you have mono sound, insert the audio cable into the left audio jack.)

NOTE: You may use VIDEO or S-VIDEO inputs to connect to INPUT 3 and 4, but only one of these inputs may be used at a time.

MONITOR OUT

These jacks provide fixed audio and video signals which are used for recording. Use the S-VIDEO Output for high quality video output.

NOTE: Only ANT C source and the input of an S-VIDEO signal will output S-VIDEO.

AUDIO TO HI-FI Output

These jacks provide variable audio output to a separate stereo amplifier. With this connection, the audio to the stereo can be controlled by the television’s main volume.

CENTER IN (Input)

This jack is for stereo amplifiers with center signal capability. This feature allows the TV speakers to be used as a center speaker. The TV must be set as a center channel by selecting “TV as Center” on the Audio Advanced Settings Menu (see page 52).

S-VIDEO Inputs 3 and 4

Inputs 3 and 4 provide S-VIDEO (Super Video) jacks for connecting equipment with S-VIDEO output capability.

9