Manual Convergence Adjustment Mode

VIDEO

NOTES: 1. Please turn ON your television for at least 20 minutes before using this feature.

2.Auto Adjustment Mode is recommended. If convergence is still not acceptable, use the Manual Adjustment Mode. DO NOT press MAGIC FOCUS or use Auto Adjustment Mode after using Manual Adjustment Mode.

Using the Remote Control, select VIDEO-MAGIC FOCUS-MANUAL ADJUSTMENT MODE-START to access convergence crosshatch pattern. The adjustment point is indicated by the Adjustment Point Cursor.

To Move Adjustment Point

To move the adjustment point cursor using the THUMBSTICK, the Adjustment Cursor must be WHITE. Another way to move the Adjustment Point Cursor is to press the following buttons: [2] up, [4] left, [5] down, [6] right. If you use the number buttons while the adjustment point is WHITE, it will change to RED.

To Change the Color of Adjustment Point

Press the SELECT button repeatedly (WHITE-RED-BLUE-WHITE...). Green color is fixed and cannot be adjusted.

To Adjust the Convergence

Move the Adjustment Cursor to the point to be adjusted. Use the THUMB STICK to match the RED and BLUE colors to GREEN (reference color). Properly aligned, all three colors should appear white.

	Video
	Audio
	Ch. Manager
	Locks
	Setup
MENU	Move SEL	Sel
MENU

Video

Magic Focus

Aligns the Red, Green, and Blue colors to correct for Magnetic Influences.

Adjustment Mode

Auto	At Turn Off
Manual	(After 90 days)

If you want to adjust now Start

THUMB	THUMB
STICK	STICK
SELECT

THUMB

STICK

SELECT

THUMB	THUMB
STICK	STICK
	SELECT

Video
Picture Mode	Sports
Contrast	100%
Brightness	50%
Color	50%
Tint
Sharpness	50%
Vertical Position
Magic Focus
Color System
Advanced Settings
Move SEL Select
	Adjustment Point
	Cursor

ON-SCREEN DISPLAY

Move SEL Return

If convergence is acceptable after Manual Convergence adjustment, press EXIT button to access menu mode.

DONE	: [1]
CANCEL	: [2]
EXIT
INI. RESET :		[3]
BACK	:	[4]

Press the [1] button on the remote control to SAVE adjusted data and return to main picture. Press the [2] button on the remote control to CANCEL adjusted data and return to main picture. Press the [3] button on the remote control to recall the factory pre-set convergence data.

Press the [4] button on the remote control to return to the manual convergence adjustment mode (crosshatch pattern).

Press the [9] button on the remote control to read the SAVED adjusted data. If there is no saved data, pressing the [9] button will recall the factory pre-set data.

VIDEO