Hitachi 43GX10B, 50DX10B, 50GX30B, 60DX10B HOW to SET UP Your NEW Hitachi Projection TV, Antenna

Page 6

HOW TO SET UP YOUR NEW HITACHI PROJECTION TV

ANTENNA

Unless your TV is connected to a cable TV system or to a centralized antenna system, a good outdoor color TV antenna is recommended for best performance. However, if you are located in an exceptionally good signal area that is free from interference and multiple image ghosts, an indoor antenna may be sufficient.

LOCATION

Select an area where sunlight or bright indoor illumination will not fall directly on the picture screen. Also, be sure that the location selected allows a free flow of air to and from the perforated back cover of the set.

To avoid cabinet warping, cabinet color changes, and increased chance of set failure, do not place the TV where temperatures can become excessively hot, for example, in direct sunlight or near a heating appliance, etc.

VIEWING

The major benefit of the HITACHI Projection Television is its large viewing screen. To see this large screen at its best, test various locations in the room to find the optimum spot for viewing.

The best picture is seen by sitting directly in front of the TV and about 10 to 18 feet from the screen. Picture brightness decreases as the viewer moves to the left and right of the receiver.

During daylight hours, reflections from outside light may appear on the screen. If so, drapes or screens can be used to reduce the reflection or the TV can be located in a different section of the room.

If the TV s audio output will be connected to a Hi-Fi system s external speakers, the best audio performance will be obtained by placing the speakers equidistant from each side of the receiver cabinet and as close as possible to the height of the picture screen center. For best stereo separation, place the external speakers at least four feet from the side of the TV, place the surround speakers to the side or behind the viewing area. Differences in room sizes and acoustical environments will require some experimentation with speaker placement for best performance.

 

 

￿

 

 

￿￿￿￿￿￿￿￿￿￿

 

￿￿￿￿￿

 

 

￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿

￿￿

￿￿

￿￿￿￿￿

￿￿

￿￿￿￿

￿￿￿￿￿

￿￿￿￿￿￿￿￿￿￿

￿￿￿ ￿￿￿ ￿￿￿

￿

 

￿￿

 

 

￿￿￿￿￿￿￿￿￿￿

 

 

 

 

￿￿

￿￿

￿￿￿

￿￿￿

￿￿￿

￿

￿￿

￿￿￿￿￿￿￿￿￿￿￿￿￿

￿

CAUTION: Magnetic fields, such as those of external speakers, may cause the picture to distort if they are placed too close to the television. Move the magnetic field source away from the television until there is no picture distortion.

6

Image 6
Contents 43GX10B 50DX10B 50GX30B 60DX10B Important Safety Instructions Refer Servicing to Qualified Service PersonnelImportant Safety Instructions Safety Tips Operation of Your TelevisionAccessories Remote ControlPart Name Illustration Location HOW to SET UP Your NEW Hitachi Projection TVAntenna ViewingHOOK-UP Cables and Connectors Antenna Connections to Rear Jack PanelFront Panel Controls Perfect Picture sensor Power lightRemote Control sensor Digital ArrayRear Panel Jacks Way signal splitter Rear Panel ConnectionsConnect After Turning the Power of the TV OFF Rear Speaker Terminal ConnectionsConnecting External Audio Amplifier External ConnectionsConnecting External Video Sources Connecting a Monaural Audio VCR or Laserdisc PlayerBefore Operating External Video Source Connecting a Stereo VCR or Stereo Laserdisc Player Optional, see tips onConnecting a Stereo Laserdisc Player or DVD Player to Input Audio System Setup Surround Required Optional Effect Feature Switch ConnectionPrecoded VCR/DVD codes Remote ControlPrecoded VCR/DVD Buttons TV/VCR ButtonHOW to USE the Remote to Control Your TV PICTURE-IN-PICTUREMENU, SELECT, Cursor buttons Last Channel buttonVIDEO1 VID1 StereoST/SA Taka VIDEO2 VID2PIP CH buton Help buttonPICTURE-IN-PICTURE PIP PIP buttonSwap button Move buttonCursor buttons PICTURE-IN-PICUTRE PIP Freeze buttonQuick Freeze button Using the Remote to Control VCR Functions Operating the precoded function for your VCRUsing the Remote to Control DVD Functions Operating the precoded function for your DVD PlayerUsing the Remote to Control Cable BOX/SATELLITE Functions Operating the precoded function for your cable/satellite boxCABLE, SATELLITE, VCR, and DVD Codes Ultratec OSD Theater SET UP Menu LanguageSignal Source Reception BandAuto Channel SET Channel Memory Cursor Channel ListR S O R Clock SETRed Custom Channel IDVideo ID Family Favorites Menu Family Favorites Operation Parental Control Customize Use number buttons to enterEvent Prog Auto Link Mode Closed CaptionDisplay ChannelContrast Brightness Color Tint ResetVideo SharpnessPerfect Picture Advanced SettingsColor Temperature Auto ColorTreble AudioBass BalancePerfect Volume MTS ModeAuto Noise Cancel Internal SpeakersTheater Theater ModesCare of Your Hitachi Projection TV Your Remote Control Do notReception Problems ¥ Ignition NoiseSymptoms Useful InfoOutputs SpecificationInputs 43GX10B 50DX10B 60DX10B 50GX30BHitachi Home Electronics DivisionPage Page Page QR47632