Mitsubishi Electronics WT - 42313, WS - 65313 DVD position, LD Player Audio position Receiver

Use of the Remote Control with Other A/V Products

	CABLE/DBS/DTV	VCR		DVD
	TV				AUDIO	2.POWER
1.
3.		DVD Player Codes
	DVD/LDP brand		Code to enter:			If your
	Mitsubishi	003				DVD
	JVC	257				code is not
						listed here,
	Panasonic	250
						please see
	Philips	258, 253, 272
						page 66
	Pioneer DVD	252
						for a
	Samsung	261
						complete
	Sony	254
						listing.
	Toshiba	253
	To reset to default code, enter 000

Figure 4. Programming the remote to control your DVD or LDP.

	CABLE/DBS/DTV		VCR		DVD
	TV					AUDIO	2. POWER
1.
3.		A/V		Receiver Codes
	Audio brand			Code to enter:			If your
	Mitsubishi A/V receiver			010, 015, 011, 012,
							audio
	and/or CD player			013, 014
							code is not
				234, 235, 236, 245,
	Denon						listed here,
				246, 359			please see
	Harman Kardon			215, 223, 242			page 66
	JVC			233, 232			for a
	Kenwood			208, 200			complete
	Marantz			224, 350			listing.
	Onkyo			209, 214, 240, 247
	Pioneer			205, 207
	Sony			222, 249
	Technics			218, 219, 221
	Yamaha			202, 201, 243, 244
	To reset to default			code, enter 000

Figure 5. Programming the remote to control your A/V receiver.

If the slide switch is set to TV when you enter an A/V receiver code, VOLUME and MUTE will control the A/V receiver rather than the TV. To return volume and mute control to the TV, set the slide switch to TV, press and hold POWER and enter 000.

After entering the correct codes in each position of the remote control, use the slide switch to select which product will respond when an operational button is pressed. If you enter a code from the AUDIO chart while the slide switch is set to TV, the volume and mute functions change to match the A/V receiver. This is useful when using an A/V receiver with the TV all the time. In all other cases, only one of the below devices is allowed for each slide switch position.

TV position:

TV

A/V receiver (volume and mute only)

Cable/DBS/DTV position:

Cable box

Satellite receiver

DTV receiver

VCR position:

VCR

DVD position:

DVD

LD Player

Audio position:

A/V receiver

Mitsubishi CD player

If you have a Mitsubishi A/V receiver, the audio position may be used in conjunction with select Mitsubishi CD players. Your audio position must be programmed to either 010 or 011. Plug the CD player power cord into a switched outlet on the back of your A/V receiver. Pressing the POWER button turns On the A/V receiver, along with the CD player. In the audio position, for some CD players, the transport controls (FF, Play, Rew, etc.)

operate the CD player.

Some manufacturers may change their products, or they may use more than one remote control system. If this is the case, your remote control may not be able to operate your VCR, DVD, cable box, satellite receiver, or A/V receiver.

28