Mitsubishi Electronics WS - 55313, WT - 42313 manual Connecting an Antenna to a Cable Box or VCR

Connecting an Antenna to a Cable Box or VCR

Note: The TV back panel and connections shown here are for reference only and may vary by model.

��������
�����	�

�

�������������������������������

	� �� �
�� � � �	��� � � � � �

�

Cable Box

(Figure 3)

1.Connect the incoming cable to ANT-A on the TV back panel.

Connect two coaxial cables as follows:

2. One from LOOP-OUT on the TV back panel to IN

on the cable box back panel.

3. One from OUT on the cable box back panel to

ANT-B on the TV back panel.

���������

�������������������������������

�����

Figure 3. Connecting the cable box.

Note: See page 5 for Outdoor Antenna Grounding

NOTE: If your cable box has separate audio/video outputs, please see Composite Video with Audio or S-Video with Audio, page 16 (Figure 6).

��������������

�������������������������������

	� �� �
�� � � �	��� � � � � �

�

�

Antenna or Wall Outlet Cable

(Figure 4)

1.Connect the incoming cable to ANT-A on the TV back panel.

Connect two coaxial cables as follows:

��������������

	�	��������	���������
	���������
��	�	�	�����
	�	�	�
�������			�������

2.	One from LOOP-OUT on the TV back panel to
	ANTENNA IN on the VCR back panel.
3.	One from VCR back panel ANTENNA OUT to
	ANT-B on the TV back panel.

�

���

� �

NOTE: If your cable box has separate audio/video

Figure 4. Connecting the VCR with antennas or wall outlet table.

outputs, please see Composite Video with Audio or S-Video with Audio, page 16 (Figure 6).

Note: If you have a digital cable box, refer to your Digital Cable Box owner’s guide for instructions on optimal connections to this TV.

Note: For models WS-,WS- and WS-, when the Energy Mode is set to Low, the VCR may not record programs, when the TV is off.

15