Mitsubishi Electronics 837 SERIES, 737 SERIES manual Receiver with Hdmi Output

202. TV Connections

A/V Receiver

Most setups require either a digital audio cable or analog stereo audio cables. To send audio from TV channels received on the ANT input or devices con- nected directly to the TV, you must use one of the connections shown below. Usually, only one of these connections is required.

The TV makes all audio available in digital and analog formats:

•Analog audio coming into the TV is available as output in digital stereo format on the DIGITAL AUDIO OUTPUT jack.

•Digital incoming audio is available as analog output on the AVR AUDIO OUTPUT L and R jacks.

		AVR L			TV main panel
		AUDIO					RS-232C
		OUTPUT
		R
					DVI/PC INPUT			ANT
					R AUDIO L
			AVR	L
	HDMI		AUDIO		Y/ VIDEO	Pb	Pr	3D
			OUTPUT
							2	GLASSES
1	2	3		R			INPUT	EMITTER
					Y/ VIDEO	Pb	INPUT 1
							Pr
				DIGITAL	R AUDIO L	(480i / 480p / 720p / 1080i)		IR-NetCommand
				AUDIO				Output
				OUTPUT
					DIGITAL
					AUDIO
					OUTPUT

Stereo analog	Digital coaxial cable
cables
(for an analog	(for a digital A/V
A/V receiver)	receiver)

OPTICAL

INPUT

COAXIAL

INPUT

A/V receiver back panel

Note:

•On rare occasions, an HDMI signal may be copy-restricted and cannot be output from the TV as a digital signal. To hear these copy- protected signals through the A/V receiver, use the connection for an analog A/V receiver.

•Check the A/V receiver’s Owner’s Guide for information concerning use of the digital input and switching between digital sound and analog stereo sound from the TV.

A/V Receiver with HDMI Output

Required: One HDMI-to-HDMI cable

This option allows you to view content from devices connected to an A/V receiver. The A/V receiver can send audio and video to the TV over a single HDMI cable. You can use an HDMI connection as described here in addition to an audio connection from the TV’s audio output. The optional audio connection allows you to hear, through the A/V receiver, devices connected to the TV only, e.g., an antenna on the ANT input.

You may be able to use the TV’s remote control (in TV mode) to operate connected CEC-enabled HDMI devices. Experiment with your equipment to determine which functions are available to the TV’s remote control. See Appendix C, page 67.

837 Series: This setup allows you to use NetCom- mand-controlled audio and video switching over the HDMI cable. See “Case 3: Automatic Audio and Video Switching via HDMI” on page 55.

To use NetCommand to supplement HDMI control of a CEC-enabled A/V receiver, note the recommendations under “More About Using an HDMI Connection,” page 55.

					DVI/PC INPUT				ANT
					R AUDIO L
			AVR	L	TV main panel
	HDMI		AUDIO		Y/ VIDEO	Pb	Pr		3D
			OUTPUT					2
									GLASSES
1	2	3		R			L	INPUT1	EMITTER
						AVR		INPUT
					Y/ VIDEO	AUDIO	Pr
				AUDIO	R AUDIO L	OUTPUT	R		Output
				DIGITAL		(480i / 480p / 720p / 1080i)			IR-NetCommand
				OUTPUT

DIGITAL

AUDIO

OUTPUT

Optional analog or digital audio connection

A/V receiver
with HDMI
output HDMI OUT DIGITAL L R
	AUDIO
	VCR
High-definition
DVD player	DVD player
	Cable box