One for All URC-9990 manual Programming the Home Theater Power Macro

Esc THEATER SETUP OK Setup THEATER

Setup

THEATER

Press OK to save.

TV CBL VCR

Tap on

TV	CBL	VCR	TV	CBL	VCR
				Vid Out

V C R

TV/VCR

1

4

7

2

5

8

0

PWR	V
3	C
	R
6
9	C
	D

Track- Shuffle Track+

8.If you want to test Home Theater, press down on ESC or MUTE for at 2 seconds to return to the last-displayed Device Screen. Then tap on the THEATER Key to see the composite screen (see example).

NOTE: Depending on the devices you program, the Home Theater composite screen on your MOSAIC may look different than the one shown in the example above.

PROGRAMMING THE HOME THEATER POWER MACRO

1.If necessary, perform steps 1 through 3 of the previous section (Programming Home Theater Devices on page 33) to view the Theater Setup Menu.

2.In the Program Power Macro sub-menu, tap on the NEW key. You will see the THEATER SETUP Device Selection Strip.

NOTE: Tapping on the NEW key will also override any previously-programmed Power Macro.

Esc THEATER SETUP ?

Configure the remote control to match your Home Theater.

What device is used for:

Video Playback	VCR
Audio Playback
	CD

Menu Source

Audio Source

Pro-Logic

Channel Source CBL

PIP

Program Power Macro

Tap on NEW

Esc THEATER SETUP

Begin recording the keystrokes.

TV CBL VCR

TV/VCR PWR

1 2 3

4 5 6

7 8 9

0

3.Using a procedure similar to the one described in Adding A Macro (starting on page 12), tap on successive devices and their functions to program the macro.

4.After you have programmed the macro, aim MOSAIC at your Home Theater system and tap on the TEST key. If the devices respond incorrectly, tap on the CLEAR key and repeat steps

3 and 4.

34 www.oneforall.com