One for All URC-6231, URC-6230 instruction manual Set Up, Direct code set up

SET UP

Direct code set up

Example: To set up the ZAPPER for your Television follow the instructions below.

1Make sure your TV is switched on (not on standby).

2Find your Television code in the Set-Up Code section (page 52-66). Codes are listed by brand name. The most popular codes are listed first.

3Open the flap to enable access to the MAGIC key.

4Press the TV key.

5Press and hold the MAGIC key until the LED blinks twice (The LED underneath the POWER key will blink once then twice).

6Enter your 5-digit code according to the chart below. The LED underneath the POWER key will blink twice.

UP = 3

LEFT = 2 RIGHT = 1

OK (MUTE) = 5

DOWN = 4

7Now, aim the ZAPPER at your Television and press POWER. If your

Television switches OFF, your ZAPPER should be ready to operate your device.

8If the functions do not work properly, repeat steps 4 –7 using another code listed under your brand.

For example: To enter a Sony TV code 33121, you would press CHANNEL +, CHANNEL +, VOLUME +, VOLUME -, VOLUME +.

To set up your DVD player or Satellite Receiver please press the corresponding device key during step 4.

Important notes:

-Some codes are quite similar. If your television does not respond or is not functioning properly with one of the codes, follow steps 1-5 with each code listed for your brand.

-If none of the codes listed for your brand operate your television, follow the Search Method described in the next section. The Search Method can be used even if your brand is not listed at all.

TV

DVD

SAT

■ ■ ■ ■ ■

■ ■ ■ ■ ■

■ ■ ■ ■ ■

4 WWW.ONEFORALL.COM