Audiovox TV Cables manual LDchoring Cable Assembly

INSTALLATION , ,

lDchoring Cable Assembly (Continued)

t General Motors Blank Anchor

--, .

1.To locate the blank anchor on General Motors vehicl~, jljs necessaryto remove the air cleaner. The blank anchor is located above the throttle anchor .

2.This anchor is hollow except at one end. Use a 114"bit and drill as shown in Figure 23.

3.Before using the 114"-20 Nut, remove the Adjustable Sleeve from the Cable A3sembly. Then use the 114"-20 Nut to fonD threads

on the end of the Cable Assembly. This is easily accomplished by first placing the 114" -20

Nut on the end of the Cable Assembly with

your fingers and then use a 7116" box end wrench and tucfnclockwise until the desired ,

amount of threads have been formed. (Figure 19, pa&e 14)

4.Insert the Cable Assembly through the blank anchor and thread the other 114" -20 Nut in place. (Figure 2.4)

PROCEDURES

I Drill	114"
This	Side	Anchor

FIGURE 23

, -;, ,

5. The 114" -20 Nut cali .be used if there is a pre-existing 114" hole in a bracket on the vehicle

or if it islX>SSible to drill a 114" hole in a bracket

I

on the vehicle. (FIgure 26)

Form 1#4313, Page 15 i