INSTALLATION PROCEDURES
~NG | CABLE | (continued) | I |
2.Attach the Bead CbaiD to the Two Bead Connector; SecurebeadSby folding down the metal tabs. The following parts will be
usedwhen installed properly:
Two Bead ConDector, Bead Cb~D, Bead CbaiD CoDnector, and Bead
CbaiD CoDDector Cover. | (Figure 16) |
3.Remove clip or pin which retains throttle cable (and washer if provided) and install Two Bead Connector on the sameside of throttle cable as the Cable Assembly will be anchored. This is necessaryso that Cable Asaeinbly and throttle cable will not cross.
4.The Two Bead may need to be bent so that it clears the throttle cable. (Figure 17) Also, the 4" Tie Strap can be used to hold the Two Bead Connector to the sleeveof the throttle cable. (Figure 17)
NOTE: After the Cable Assembly has been Attached, manually move the throttle to assure the Cable Assembly does not hang up on any part of the vehi~le.
1,GM. Ford. and Chrvsler Throttle
Usin~THRQ1TLE CLIP WlTHCABLE
I.Some OM, Ford. and Cbrysler vehicles
have an attachment stud qn ~e throttle pulley .
2.Slide a Bead Chain Connector Cover over the cruise cable, then attach the Bead Chain Connector to the cable. Attac~ the Throttle Clip with Cable to the Bead Chain Connector And slide the Connector Cover over the Bead Chain Connector. (Figure 18)
3.Slide the Throttle Clip over the throttle pulley attachment stud. Push Throttle Clip onto the stud until it snapsfirmly onto the Stud.
Throttle Clip with
FIGURE 18