Audiovox TV Cables manual Control Switch Tests

If all 01 die previous functions are correct, check the T ACB Signal

I. Turn the Cnaile Coatrol Switch to the OFF position

2.Turn the ignition switch to the OFF position

3.Press and hold the RESUME/ACCEL slide switch while you turn the ignition switch to the ON position and start

lie	.,.g;,.e. Now release the RESUME/ACCEL					slide switch. (If you are using a 250-3592	or 250-3593	dash mount
Cnile Coatrol Switch, turn the ignition switch to the ON position and stl111the engine, hold the RESUME/ACCE
.button	00wn	while	you turn the Cruise		Control	Switch to the ON position.)
4. The Diagnostics LED should be flashing. Rev the engine, the LED should flash faster at higher RPM's. If not:
	.Check		steps to entering	diagnostic		mode and tJy again
	.Connection		to T ACH Signal		source is bad		~	0-
	.T	ACH	Signal connection	point is not correct

CONTROL SWITCH TESTS

,. .* tat:

I.Unplug the S-pin connector from the Actuator Assembly.

2.Ground the test light lead and verify that the test light works by proving with a known po~er source.

			TES:It'HART A
	IGNITION		CONTROL
	SWRCB		SWITCH
;	POSmoNS-		POSITIONS
j	orr		OFF
I ,	orr		-
			ON
	OFr		ON
			press and	bold
			SET/COAST
	On'		ON
			press and	bold
			RESUMEI ACCEL
	ON		-ON
	CaANKor		ON
			TEST CHART .
	IGNmON		CONTROL
	SWITCH		SWITCH
		i	POSITIONS
-POS~NS		I	OFF
:	iiij		~
	OFf		ON
			press and	bold
			SET/COAST
	orr		ON
			preu and	bold
			RF.SUME/ACCEL
	ON		ON
	C84NK	or	ON

(FOR~LOSED CIRCUIT ~QNTROL sWITcm

RED	DARK	YELLOW
	GREEN	OFF
~	OFF
OFF
ON	ON	OFF
ON	OFF	ON
ON	ON	ON
ON	ON	2!!
ON	-
	ON	OFF

-~

(FOR OPEN CIRCUIT-~ONTROL swITcm

RED		DARK	YELLOW
		GREEN
OFF		OFF	OFF
-		OFF	-
-~N			OFF
ON	~c--	ON	OFF
		"=-.
ON		OFF	ON
~		OFF	OFF
		OFF	-
ON			OFF

BROWN

OFF

~

BRO~

OFF

OFF

ON

,- NJI.1, ..ce 10