~arness | Assembly | I |
Push Rubber Cover Grommet securely into place on the cover of the Actuator Assembly. (Figure 30)
Straighten the Harness Assembly and find the 4 pin mating connectors. Separatethe 4 pin connectors. A small screw driver may be needed.
Bamess Assembly needs a 314" hole to pass through bulkhead. You may find one nearby such as the speedometer cable hole or a small one you can file larger. If you find the right size hole in the right place, remove ru~r grommet. If not, drill, saw, or punch a 314" hole in bulkhead. A hole a couple of inches to the left or: slightly higher than the steering column is usually a ~00d place. (FiEUre 31)
OTE: Check inside before drilling, sawing, or linEso you don't dama!e anything.
From engine side, passfour pin connector and VIOLET wire through hole. If you did not hook up the BLUE TACH wire and GRAY VSS wire under the hOOd,passthem through to the inside also.
Reattach 4 pin mating connectors and make necessarywire connections. (See page 18)
eat hole in bulkhead with Sealing Putty as shown
1 Figure 32.
,
~~
~
)