Clover Electronics CDR 4170 instruction manual PTZ Control, Order Camera Title

7.PTZ CONTROL

1.Connect Pan/Tilt/Zoom camera’s control to RS485(+) / RS485(-) port on the rear of the system.

2.The video output of Pan/Tilt/Zoom camera to the one out of channel you wish to connect.

3.Press and hold the PTZ button for about 3 seconds on the front panel and the PAN/TILT CONTROL screen will be displayed on the monitor.

4.Can select the order for control that user wants to do whenever ENTER button is pressed. MOVE: Change the position of screen shown on Pan/Tilt Zoom camera.

ZOOM: Change zoom in/out value of the screen shown on Pan/Tilt Zoom camera.

FOCUS: Change focus value of the screen shown on Pan/Tilt Zoom camera.

CH SEL: Select the channel that is connect to Pan/Tilt Zoom camera.

5.After finishing setup, Press the ESC button to exit.

NOTE

•Connect only one Pan/Tilt/Zoom camera on the system.

•The protocol of P/T/Z camera should be Pelco-D Protocol.

•The baud rate of P/T/Z camera must be 2,400bps (bit per second).

ORDER

CAMERA TITLE

- 39 -