AVE MV DR16X, MV DR8X, AVE DR16X, AVE DR8X Record Schedule / Quality Setting, Record Mode, DST Bias

Page 23

User’s Manual

DST Bias

The item allows user to set the amount of time to move forward from the standard time for daylight saving time. The available options are <30>, <60>, <90> and <120> minutes.

3.6Record Schedule / Quality Setting

The Record Setup menu allows user to set recording quality, recording schedules, and other recording parameters. Administrator's password is required to use Record Setup menu. In the Main menu, move the cursor to <Record Setup> and press ENTER; the following menu is displayed.

 

Record Setup

 

1. Record Mode

720×240@120PPS

2.

Schedule Setup

 

3.

Preset Config

Standard

4.

Per Camera Config

 

5. esRecord Setup

 

6.

Data Lifetime

0 Days

7.

Pre-Alarm Recording

15 Sec

8.

Circular Recording

ON

9. Audio Recording

ON

10. Purge Data

 

3.6.1Record Mode

The Record Mode is for selecting resolution and recording rate. The relative record settings, such as preset configuration, will follow the record mode setting. In normal circumstance, we recommend you to select <720 × 240@120PPS> (<720×288@100PPS> in PAL format).

Move the cursor to <Record Mode> and press ENTER, then select a Record mode using UP / DOWN keys.

NOTE: After changing the Record Mode setting, the warning message “This will FORMAT ALL HARDDISKS and LOAD THE FACTORY DEFAULT CONFIG!” will be shown on the screen. Press ENTER to confirm the selection, then the unit starts to format the hard disks and load the factory default settings, or press ESC to abort.

We strongly recommend to backed up your programmed configuration before making any changes on Record Mode settings.

22

Image 23
Contents Ver User’s Manual User’s Manual Rack Mounting Important InformationTable of Content Sequence with Main Monitor Sequence with Call Monitor Overview Product Key FeaturesUser’s Manual System Setup Product Application DiagramSelecting Video Format Connecting Devices to the UnitConnecting Required Devices Position the UnitCall Monitor BNC Connecting Short-term DeviceRear Panel Connections Main Monitor S-Video / BNCCamera Looping LAN Connector RJ-45Power Jack Power SwitchRS-232C Alarm I/O & RS485USB Connector VGA OutLED Definition General System SetupFront Panel Introduction Functional Keys Fast Forward Fast RewindCall/ Copy Instant RecordSEQ Sequence Direction Keys Install HDD to the UnitReboot Power Up / Down the UnitTo Power Up the Unit Power OffAdministrator Password User Password Entering OSD Setup MenuDate / Time Display System Date / Time SettingSet Date / Time Set Date / TimeDaylight Saving Time DST Bias Record Schedule / Quality SettingRecord Mode Normal PPS Normal Size Event PPS Event Size Schedule SetupPreset Record Configuration To Record Event Video Only Per Camera ConfigurationViewing in Full Screen Basic OperationViewing Live / Playback Video Viewing ModesViewing Recorded Video Digital ZoomViewing Live Cameras To Freeze Live ImagePause Playback and Single Step Forward Key Usage in PlaybackDual Main Output For Unit with Turbo Module Viewing Live Image in Playback ModeSequence with Call Monitor Sequence SetupSequence with Main Monitor Searching Recorded Video Searching by Event Searching by TimeVideo Export Export from OSD Setup MenuSelect Select the External DeviceDevice Name AvailableSelect Events Select Video for ExportingSelect Channel From / To TimeExport Format Digital SignatureErase Disc Quick Video Export through Front PanelTo Export Normal Video EzBurn IntroductionTo Export Event Video Purge All Event Data Deleting Recorded VideoDome Control Purge All DataDome Connection Dome Protocol Setup3 RS485 Setup Dome Controlling Key Pan / Tilt Setting Preset PointsZoom Out Calling Preset Points All specifications are subject to change without notice Appendix a Technical SpecificationsUser’s Manual