Getting Ready
Step Action
1Select your cleaning chemistry (check with your chemical supplier for solution effects on metals).
2Allowing for the volume of the parts you will be cleaning and cleaning chemistry, fill the tank with warm tap water to the operating level (one inch from the top).
3Add cleaning chemistry to the tank water.
4Plug the cleaner into a grounded outlet.
5For maximum efficiency, refer to page 9, “Optimizing Your Cleaner” before proceeding.
NOTE:
If this is the first time you are running the cleaner, or if you have changed cleaning solution, you must degas the solution. This is done by setting the cleaner up for operation and allowing the ultrasonics to drive the warm solution for
Cleaning Items
Step Action
1Place the items to be cleaned into a basket or perforated tray.
2If using a solid container, add cleaning solution to the container to cover the items.
3Slowly lower the tray into the tank. Do not allow items to contact the tank bottom. Do not stir the solution.
4When items are clean, slowly remove them from the cleaner.
5Rinse the clean items with fresh water and dry them, if necessary.
8Operating Your Cleaner