Optimizing Your Cleaner
Tanks
Cleaning - check the tank for contamination whenever you change solution. If necessary, remove contaminants with a nonabrasive cloth and water.
Emptying - always unplug the cleaner before emptying the tank. Dispose of the contents in an environmentally responsible way.
Filling - always unplug the line cord before filling the tank. Fill the cleaner to the operating level (one inch from the top with beaker/tray in place), using warm tap water.
Low solution level - will cause the cleaner to fail. When you remove heavy or bulky loads from the cleaner, the solution level may drop below the operating level. If so, be sure to replace lost solution and degas, if necessary, depending on the amount used.
Overload - do not rest any items on the tank bottom. Weight on the tank bottom dampens sound energy and will cause damage to the transducer. Instead, use a basket or other method to support all items. Allow at least one inch between the tank bottom and the parts or receptacle for adequate cavitation.
Covers - allow the cleaner to heat up faster, to a higher temperature, and avoid excessive liquid evaporation. However, leaving the cover on with heat and ultrasonics can cause the solution to boil, diminishing effectiveness.
Temperature
Heater - the heater may cause some discoloration of the tank wall. This is normal and will not affect the performance of the unit.
Solution - the fastest method to get your cleaner to the best operating temperature is to fill it with warm solution, turn on both the heat and ultrasonics, and use a cover.
9Operating Your Cleaner