Record Setup, Record Configuration, Multiplex

5-4. RECORD SETUP

This is the most important configuration of the DVR. Enter into SYSTEM MENU-RECORD SETUP and press the [ENTER] button.

Use direction button to move and [-] [+] button to set value.

(1)OVERWRITE : Set overwrite or stop recording when the HDD is full.

-DUPLEX : Playback & Ethernet

-TRIPLEX : Playback & Recording & Ethernet

※Note: DUPLEX MODE is recommended to playback the images at a maximum frame rate.

But, it makes DVR not to record during search.

CHAP. 5 Set Up

RECORD SETUP

RECORD CONFIGURATION

SCHEDULE SETUP

HOLIDAY SETUP

SELECT MENU : ▲▼, & [ENTER]

(3) QUALITY : Set recording picture quality.

Actually it is fixing maximum data size of image for each picture quality in 5 steps as follows.

-BASIC

-NORMAL

-ENHANCED

-FINE

In Emergency recording mode, recording quality is

SELECT MENU : ▲▼, CHANGE VALUE : + -

To send more images via IP network and longer recording time, set QUALITY at NORMAL or ENHANCED and record at 360x240(360x288).

※Data size of image in PAL system is a little bigger than NTSC system, but the total recording time is same as in NTSC system.

(4)RESOLUTION : Set recording resolution.

-120 ips at 720x240(NTSC) , 100 ips at 720x288(PAL)

-240 ips at 360x240(NTSC) , 200 ips at 360x288(PAL)

※It is not possible to see those images in full screen mode in playback.

Recording in Dual resolution is recommended for higher recoding speed, and also to send more images via IP network.

(5)RECORD IN ALARM : Set record speed (skip rate) in ALARM record mode.

(6)RECORD IN MOTION : Set record speed (skip rate) in MOTION record mode.

(7)CONTINUOUS RECORD : Set record speed (skip rate) in CONTINUOUS record mode.

Set record speed (skip rate)

- 1/1x, 1/2x, ………. 1/999x record speed

- ex: 1/2x ) R->S->R->S…- ex: 1/3x ) R->S->S->R->S->S->R…

- ex: 1/4x ) R->S->S->S->R->S->S… ( R : RECORD S : SKIP )

- ex : If record resolution is set at 360x240, 1/1x = 120 ips, 1/2x = 60 ips, 1/3x = 40 ips, etc.