Maxtor DVMR manual Back-Up, External Device, TCP/IP Setup, IP Config Setup

CHAP. 5 Set Up

5-5. BACK-UP

User can back up the recorded data to CD using CD writer installed in DVR.

Refer to [START] and [END] of data on HDD and set copy from time, [START], and size of data copied, [SIZE], and move to BURN and press [ENTER] button to start copy.

	CD-R SETUP			CD-R SETUP
		HDD
HDD		[START] 2005/AUG/07 AM04:04:12
[START] 2005/AUG/07 AM04:04:12		[ END ] 2005/AUG/08 PM08:12:23
[ END ] 2005/AUG/08 PM08:12:23		CD-R	700 MB
CD-R		[START] 2005/AUG/07 AM04:04:12
[START] 2005/AUG/07 AM04:04:12		[ END ] 2005/AUG/08 PM08:12:23
[ END ] 2005/AUG/08 PM08:12:23		[ SIZE ] 700 MB - > 700MB
[ SIZE ]	000MB		BURN
BURN
		CD-RW BURNING : IMAGE DATA.
SELECT : SETUP BUTTON, JOG SHUTTLE		SELECT : SETUP BUTTON, JOG SHUTTLE

System Status Messages :

-CD-RW DOOR CLOSE. CHECKING CD-R : Blank CD check

-INPUT BLANK CD : CD writer has no blank CD.

-CD-RW DOOR OPEN : Open CD-RW and insert blank CD –R media into CD drive.

-CD-R MEDIA IS DETECTED : Blank CD-R media has been inserted and detected. DVR system will display size of blank CD-R.

After you set [START] time and [SIZE] in CD-R sub-menu and then select BURN, DVR system starts copying images to CD and shows following message.

CD-RW BURINING START

CD-RW BURNING : LEAD-IN

CD-RW BURNING : IMAGE DATA

CD-RW BURING : CLOSE TRACK

CD-RW DOOR OPEN

When burning is completed, CD-R media will be ejected automatically.

To copy more images, repeat above process. In the next back-up process, [START] time in CD-R sub-menu shall be [END] time in previous back-up, and you can copy images in series to many CDs as many as you want.

5-6. EXTERNAL DEVICE

Set parameters of external devices connected to DVR, like Ethernet, PTZ camera, RS-232C, etc. Use direction button to move to sub-menu and Press [ENTER] button to set.

1) TCP/IP SETUP

TCP/IP function enables user to see live pictures and recorded pictures via the internet.

(1) IP CONFIG SETUP :

Show the network information assigned to the DVR unit. If the DHCP setup status is AUTOMATIC, user can set the IP port only and if the DHCP setup status is MANUAL, user must set all parameters.

For detail procedure of Remote viewer program installation, refer to CHAP. 6 Software program.(Remote viewer software).

IP CONFIG SETUP

MAC ADDRESS	_ _ _ _ _ _ _ _ _ _ _
	00-0A-A2-00-00-00
IP ADDRESS	_ _ _ _ _ _ _ _ _ _ _
	192.168.001.160
IP PORT	_ _ _ _ _ _ _ _ _ _ _
	50000
GATEWAY	_ _ _ _ _ _ _ _ _ _ _
	192.168.001.001
SUBNET MASK	_ _ _ _ _ _ _ _ _ _ _
	255.255.255.000
DHCP SETUP
	AUTOMATIC

SELECT MENU : ▲▼, & [ENTER]

29