Maxtor DVMR manual Connection Setup, RS-232C Setup, PAN/TILT Setup

			CHAP. 5 Set Up
CONNECTION SETUP			DHCP SETUP
TIMEOUT	200 MSEC	DHCP MODE	MANUAL
RETRY COUNT	08	DNS SERVER	000.000.192.168
		IP ADDRESS	192.168.001.160
		SUBNET MASK	255.255.255.000
		GATEWAY	192.168.001.001

SELECT MENU : ▲▼, & [ENTER] SELECT : ▲▼, CHANGE VALUE : + -

(2)CONNECTION SETUP :

-TIME OUT : Adjust TIMEOUT value properly to successfully access to DVMR unit via Internet line. If data transmission speed is high enough, leave TIMEOUT value as set by manufacturer (200 msec), and increase it if data transmission via Internet line is relatively slow. Execute tracert (Tracing Route) in your PC for IP assigned to DVMR unit, and you can figure out how much TIMEOUT value increased.

-RETRY COUNT : Set the retry number of times for network connection.

2)RS-232C SETUP

User can control the DVR via RS-232C port. Connect DVR to PC via RS-232C port and control DVR using keyboard of PC.

This function is mainly for programmer who wants to control DVR as part of many devices connected to PC system, as in SI project.

	RS-232C SETUP
SPEED	576000
LENGTH	8
STOP BIT	1
PARITY	NONE

3) PAN/TILT SETUP

SELECT : ▲▼, CHANGE VALUE : + -

It is to set parameters for PTZ camera connected to DVR unit. DVR unit already includes all protocols of well-known PTZ cameras like PELCO D type PTZ camera, and user just select MODEL and set other parameters to control this PTZ cameras, using operation buttons on the front panel of DVR. If PTZ camera whose protocol is not incorporated into this DVR unit, user must input protocol of this PTZ camera by himself. Using USB device port, user can upgrade protocol for PTZ camera.

PAN/TILT SETUP			COMMAND SETTING
		CHANNEL	01
		MODEL	PELCO-D
		PTZ ID	000
COMMAND SETTING	Å PTZ camera set	BAUDRATE	2400 BPS
SPEED SETTING	Å PTZ speed set	CMD DELAY	1 MSEC
		COMMAND	PAN/TILT STOP
		LENGTH	0.7
		CODE	FF	00	00	00
			00	00	00	00
SELECT : ▲▼, & [ENTER]		SELECT : ▲▼, CHANGE VALUE : + -

1)CHANNEL : Select channel

2)MODEL : Select camera model (protocol type) per each channel

3)PTZ ID : Select ID

4)BAUDRATE : Select data transmission speed

5)CMD DELAY : Select command delay time

30