CHAP. 3 Installation
3-2. Detailed Installation
1) Rack mount
1. Remove 4 bolts on each side cap to install rack mount.
2.Attach rack mount bracket to DVR.
3.Attach DVR with rack mount bracket to 19” rack.
2) HDD
1.Connect Main Board and HDD1 using IDE cable and HDD power cable.
2.The jumper setting of HDD1 should be on Master if you install only one HDD.
3.The jumper setting of HDD1 should be on Master and HDD2 should be on Slave if you install two HDDs.(Refer to the above figure)
4.Stick the HDD absorber (included in package) on the bottom of case and then install the HDD on top of them by using the bolts (included in package).
5.Screws must be inserted from outside of the case bottom.
10