Maxtor 4Channel Stand-alone DVMR manual Connector Pin Assignment Description, RS-232C ASCII-code

									CHAP. 3	Installation
8) Connector Pin Assignment
No			Description			NO			Description
1	DCD		Data Carrier Detect			6	DSR		Data Set Ready
2	RxD		Receive data			7	RTS	RS232C: Rx/Tx data
3		TxD	Transmit data			8	CTS	RS232C: Rx/Tx data
4	DTR		Data Terminal data			9
5	GND		Signal Ground
9) RS-232C ASCII-code
Following ASCII-Codes(Hexa-Code) are for programmers who want to control DVR unit
via the RS232C Port using keyboard of PC.
(The following table is based on 16ch DVR.)								All ASCII-Code is 1 Byte.
REC	‘R’	DOWN	‘J’	PTZ	‘T’	KLOCK	‘C’	CH6	‘6’	CH13	’#’
STOP	‘S’	LEFT	‘H’	ZOOM	‘Z’	QPLAY	‘Y’	CH7	‘7’	CH14	’$’
PLAY	‘P’	RIGHT	‘K’	FRZ	‘F’	CH1	‘1’	CH8	‘8’	CH15	’%’
Pause	‘A’	NEXT	‘N’	MODE	‘D’	CH2	‘2’	CH9	‘9’	CH16	’^’
SERCH	‘E’	ENTER	0x0d	PIP	‘I’	CH3	‘3’	CH10	’0’
MENU	‘M’	-	‘<‘	SEQ	‘Q’	CH4	‘4’	CH11	’!’
UP	‘U’	+	‘>’	J.SHU	‘L’	CH5	‘5’	CH12	’@’

Jog / Shuttle

Please input ‘L’ command to activate J/SHUTTLE function using keyboard of PC.

Shuttle Right 10 degree	"&<1"[enter]	Shuttle Left 10 degree	"&>1"[enter]
Shuttle Right 20 degree	"&<2"[enter]	Shuttle Left 20 degree	"&>2"[enter]
Shuttle Right 30 degree	"&<3"[enter]	Shuttle Left 30 degree	"&>3"[enter]
Shuttle Right 40 degree	"&<4"[enter]	Shuttle Left 40 degree	"&>4"[enter]
Shuttle Right 50 degree	"&<5"[enter]	Shuttle Left 50 degree	"&>5"[enter]
Shuttle Right 60 degree	"&<6"[enter]	Shuttle Left 60 degree	"&>6"[enter]
Shuttle Right 70 degree	"&<7"[enter]	Shuttle Left 70 degree	"&>7"[enter]
		Shuttle Left 80 degree	"&>8"[enter]
Jog Minus	"&-"[enter]	Jog Plus	"&+"[enter]

Shuttle : After inputting a command once, it will keep performing the command until next command.

Jog : It makes the stage staying after one time operation by command input like Button

operation.13