Philips SQM4712/27 manual Installing your wall mount

Page 5

3 Installing your wall mount

In this chapter, the basic steps to get you started are described.

BWarning

Carefully read the safety precautions in “Section 1 Important” before you install the wall mount.

3.1 Mounting the wall plate (drywall)

BWarning

For safety reasons, this LCD mount must be secured to a wood stud. The stud must be capable of supporting the combined weight of the mount and display.

1See enclosed mounting template for diagram and guide of how to mount properly on the wall.

2Using a stud finder, locate and mark the stud for securing the mount (make sure your mark is in the center of the stud). You can use your own stud finder or the one included in the hardware kit.

Note: Once stud has been located you will need to verify with a hammer and a nail

A)Simply place the nail over your mark on the wall and tap in with hammer. if the nail encounters resistance and is secure in wall you have verified a stud location

B)If it just pushes through with no resistance you will need to start over and locate the stud.

3Using the enclosed mounting template, place the diagram against the wall and mark two locations (top and bottom)

on the wall where the mount Is to be Installed. Be sure to use the center of the stud.

4With the help of another person, place the mount against the wall and level it using the bubble guide.

5While another person holds the mount in place, mark two locations (top and bottom) on the wall where the mount is to be installed. Be sure to use the center of the stud. (these marks should line up with the ones made in step 3 above using the template).

6Set the mount aside and drill a 1/4” (6

mm)pilot hole at each marked location.

7Place the mount back against the wall and secure it using the wood screws

(A) provided. Do not over-tighten these screws and do not release the mount until all screws are in place.

8Once both wood screws are in place you must tighten each one. (note: be sure not to over tighten). 1

1

3.2Mounting the wall plate (concrete/brick installation)

BWarning

For safety reasons, the concrete wall must be capable of supporting the combined weight of the mount and display.

1See enclosed mounting template for

Image 5
Contents SQM4712/27 Table of contents Your tilting wall mount BWarningsWhat you’ll also need What’s in the boxInstalling your wall mount Tip Be careful not to over-tighten the bolts Final installation Final installation and operationGuarantee and service Installation finale et Fonctionnement Installation du support muralGarantie et service Table des matièresConsignes de sécurité importantes Votre support mural inclinableOutils requis Contenu de la boîteInstallation du support mural Conseil Assurez-vous de ne pas trop serrer les boulons Installation finale Installation finale et fonctionnementGarantie et service Importante Soporte de pared basculante ÍndiceInstalación del soporte de pared Último paso de la instalaciónSoporte de pared basculante ImportanteOtros elementos necesarios Contenido del kitInstalación del soporte Page Último paso Último paso de la instalaciónGarantía y servicio técnico Page Koninklijke Philips Electronics All rights reserved