Micro DVD player does not start playback

The micro DVD player does not start playback.

The DVD micro system does not respond when the buttons are pressed.

Cannot activate some features, such as Angles, Subtitles, or multi-language Audio.

Considerable noise in radio broadcasts.

Sound cannot be heard or is of poor quality.

The remote control does not function.

The display is dark.

Low hum or buzz sound.

Low bass response.

✔Insert a readable disc with the playback side facing down.

✔Check the disc type, colour system and regional code. Check for any scratches or smudges on the disc.

✔Press SYSTEM MENU to turn off the setup menu screen.

✔Cancel the parental control rating function or change the rating level.

✔Moisture has condensed inside the system. Remove the disc and leave the system turned on for about an hour.

✔Disconnect the power plug from the outlet and insert again.

✔Multi-language sound or subtitle is not recorded on the DVD.

✔Changing the language for the sound or subtitle is prohibited on the DVD.

✔The features may not be available on the disc.

✔Tune in to the correct frequency.

✔Connect the antennas.

✔Fully extend the FM wire antenna. Position for best reception and secure to a wall.

✔Connect an outdoor FM or MW antenna.

✔Adjust the direction and position for best reception.

✔Place the antenna farther away from any equipment that may be causing the noise.

✔Increase the distance between the system and your TV or other equipment.

✔Select the correct source (DISC or TUNER, for example) before pressing the function button.

✔Point the remote control at the remote sensor of the unit.

✔Reduce the distance to the player.

✔Remove any possible obstacles.

✔Replace the batteries with new ones.

✔Check that the batteries are loaded correctly.

✔Press DIM again.

✔Place the DVD micro system as far away as possible from electrical devices that may be causing interference.