Connections
English
Connecting antennas
MW Indoor Loop Antenna
Connect the supplied MW loop antenna’s wires to AM AERIAL jack. Place the antenna on a shelf or attach it to a stand or wall.
1 
2
FM Indoor Antenna
It is unnecessary to connect the FM pigtail antenna since it is fixed to the main unit. Extend the FM antenna and fix its ends to the wall.
Notes:
–Adjust the position of the antennas for optimal reception.
–Position the antennas as far as possible from your TV,VCR or other radiation source to prevent unwanted interference.
Connecting the control cable
Connect the serial port marked “CONTROL CABLE” at the rear of the DVD player to the same port at the rear of the power amplifier with the supplied flat control cable.
●Connect the VIDEO OUTPUT jack to the video input jack on the TV using a video cable (yellow).
OR Option 1
Connect the
OR Option 2
Use the component video cables (red/blue/ green) to connect the DVD micro system’s COMPONENT video output jacks to the corresponding component video input jacks (or labeled as Pr/Cr Pb/Cb Y or YUV) on the TV.
Option 1 |
Option 2 |
Note:
–To avoid magnetic interference, do not position the front speakers too close to your TV.
Connecting a TV
You must connect a TV to your DVD micro system in order to view the DVD/VCD playback.
IMPORTANT!
–There are various ways to connect the system to a TV.You only need to make one of the best connections, depending on the capabilities of your TV system.
–If COMPOMENT video output jacks or
Connecting the power cord
After everything is connected properly, plug in the AC power cord to the power outlet.
Never make or change any connection with the power switched on.
36