Philips DVD590M owner manual Remote Control Setup, Battery Replacement, Using the Remote Control

Slowly slide the tray into the remote until you hear it click into place.

DVD590M_17x 6/11/2003 1:42 PM Page 15

Remote Control Setup

1 When you purchase this Player, a thin piece of plastic in the battery compartment of the remote control.This keeps the lithium battery fresh.You must remove the plastic before the remote will work.To do so, simply pull the plastic out.

Battery Replacement

A lithium battery is supplied with the remote control.You may need to replace it eventually.

1 Use your fingernail or a pointed, non-metallic object to release the battery tray. Slowly pull the tray out of the remote.

2 Remote the old battery. Replace it with a CR2025 lithium battery only. Using another battery may present a risk of fire or explosion. Make sure the “+” on the battery faces up when it is in the tray.

3

BATTERY CAUTION: Risk of fire, explosion, and burns. Do not recharge, disassemble, heat above 100˚C, or incinerate.The lithium battery may present a fire or chemical burn hazard if mistreated.

Promptly dispose of used batteries. Do not dispose of the battery in a fire. Keep the battery away from children.

Using the Remote Control

When using the remote to operate the Player, aim the remote at the IR (Infrared) sensor on the top/front of the Player (not at the TV), See page 17.

Hookups (cont’d) 15

1

Pull

1

Back or

bottom of

remote	2
	CR 0	2	5

3V

3	Press
CR2025

Pull

2

2	2	5
CR 0
3V
3

CR2025 3

2	2	5
CR 0
CR2025		Push
3V
3

Using the Remote Control

Always point the remote control directly at the remote sensor (IR or infrared) on the front of the Player, not the TV. Details are on page 18. Make sure there are no barriers between the remote control and the Player.

Remote Sensor (IR)

Base Installation

The Base should be attached to the DVD Player permanently. Do not remove the Player from the Base.