Philips MCD510/25 Preparations, Inserting batteries into the remote control, Setting the clock

Page 20

Preparations

English

IMPORTANT!

–Make sure to complete the preparation procedures before operating the system.

Step 1: Inserting batteries into the remote control

1Open the battery compartment.

2Place two batteries (Type R06 or AA) in the compartment with the correct polarity as indicated by “+” and “–” symbols.

3Close the cover.

Using the remote control to operate the

system

1Point the remote control directly at the remote

sensor (iR) on the front panel.

2Select the source you wish to

control by pressing one of the source select buttons on the remote control (for example TAPE,TUNER).

3 Then select the desired function (for example 2;, í, ë).

CAUTION!

–Remove batteries if they are exhausted or will not be used for a long time.

–Do not use old and new or different types of batteries in combination.

–Batteries contain chemical substances, so they should be disposed of properly.

Step 2: Setting the clock

1In standby mode, press and hold CLOCK SET/ RDS on the system.

➜ “SET CLOCK” appears.Then, the clock digits for the hours flash.

2Press TUNING S T on the system to set the hours.

3Press CLOCK SET/RDS again.

➜ The clock digits for the minutes flash.

4Press TUNING S T on the system to set the minutes.

5Press CLOCK SET/RDS to confirm your setting.The system will store the setting automatically.

➜ The time setting becomes effective.

Note:

–The clock will be cancelled when the power cord is disconnected or if a power failure occurs.

–During setting, if no button is pressed within 30 seconds, the system will exit clock setting mode automatically.

20

Image 20

Contents DVD Micro Theatre How to connect a plug Important notes for users in the U.KMains plug Copyright in the U.KDVD/WMA-CD/MP3-CD Compatible Klass 1 laseraparat Index English176 Dansk Svenska Italiano Nederlands DeutschContents Clock/Timer Tape Operation/RecordingFeatures Supplied accessoriesGeneral Information Discs for playbackEnvironmental information General Information/MaintenanceCare and safety information Cleaning the disc lens Cleaning the head and the tape pathsFinding a suitable location Demagnetising the headRight LeftPlacing speakers AntennaConnecting speakers ConnectionsAntennas Connection MW AntennaUsing Composite Video jacks Cvbs Connecting TVUsing Scart jack English Using S-Video In jack Using an accessory RF modulatorConnecting the power cord Optional Connecting additional equipmentConnecting an active subwoofer B Using the VCR for recording DVDs CControls Controls on the remote control Controls on the systemEcho not for this version KEY not for this version Switching the system on Listening through headphonesSwitching the system to Eco Power Standby mode Power-saving automatic standbyInserting batteries into the remote control Setting the clockUsing the remote control to operate System PreparationsSetting language preference Setting video preferenceConnecting TV To remove the menu Press System MenuNtsc PALAuto VideoPlaying discs Using the disc menuDisc Operations Basic playback controls For CD/VCD/SVCD Fast searchProgramming favorite tracks Special disc features Playing MP3/ WMA/picture disc Kodak, JpegMixed-mode disc JpegUsing the system menu Setting language preferenceSetting video preference DVD only Setting audioNight Mode turning On / Off Setting RatingOff Use the Numeric Keypad 0-9 to enter the four-digit codeTo remove the menu To change the passwordTo play discs of rating control DVD only Tuning to radio stations Radio ReceptionProgramming radio stations Automatic programmingSetting the RDS clock Scrolling through different RDS informationTape Operation/Recording Tape playbackRewinding / Fast forwarding General information on recordingRecording timer When recording is in progressPreparation for recording Synchro start CD recording for CD onlyClock/Timer Clock settingTimer setting Sleep timer settingSpecifications Solution TroubleshootingEnglish Problem Check that the speakers are connected correctly Glossary