| AMPLIFIER |
|
|
| |
|
|
|
|
| TV |
G | F | E |
|
|
|
|
|
|
|
| I |
|
|
|
|
| AUX/VCR |
| DIGITAL AUDIO OUT | STEREO OUT |
| IN | |
|
|
| |||
| PCM/MPEG2/AC3/DTS |
|
|
| |
|
|
|
|
| II |
|
|
|
|
| TV OUT |
MAINS |
|
|
|
|
|
|
|
| R L | (CVBS) | (Y/C) |
| OPT OUT | DIG OUT | AUDIO OUT | VIDEO OUT | |
Cinemalink (on SCART)
This DVD player is equipped with cinemalink feature (from Philips) which allows a more complete control of your home audio/video (AV) equipment.
Cinemalink interconnection plug & play will enable the AV system to recognise the users intention and automatically switch the necessary controls or input source accordingly. This will reduce the necessity of having multiple control inputs for all AV equipments (eg.TV and Amplifier).
Connecting to an amplifier equipped with Dolby Surround™
Dolby Surround sound
1Connect the player to the TV, then connect the player’s audio Left and Right out jacks to the corresponding in jacks on the Dolby Surround™ Audio/Video receiver, using the audio/video cable supplied (D).
If your amplifier is equipped with a Dolby Digital™ decoder,
¶Connect the player as described in ‘Connecting to an A/V receiver with
If your TV is equipped with a Dolby Surround™ decoder,
¶Connect the player to the TV as described in ‘Connecting to a TV’.
Remote control battery installation
Loading the batteries
1Open the battery compartment cover.
2Insert batteries as indicated inside the battery compartment.
3Close the cover.
Caution: Do not mix old and new batteries. Never | h |
mix different types of batteries (standard, alkaline, | lis |
etc.) | ng |
| E |
- | + | - | + |
NTSC/PAL Settings
You can switch the NTSC/PAL setting of the DVD player to match the video signal of your TV.This setting only affects the television’s
1Unplug the DVD player from the mains.
2Press and hold 9 and T on the front of the DVD player. While holding 9 and T, plug in the mains.
3After PAL or NTSC appears on the display panel of the DVD player, release 9 and T at the same time.The PAL or NTSC that appears on the display panel indicates the current setting.
4To change the setting, press T within three seconds.The new setting (PAL or NTSC) will appear on the display panel.
General explanation
About this manual
This manual gives the basic instructions for operating this DVD player. Some DVDs require specific operation or allow only limited operation during playback. In these cases, the player may not respond to all operating commands. When this occurs, please refer to the instructions contained with the DVD. When the symbol Ä appears on the TV screen, the operation is not permitted by the player or the disc.
Remote control operation
¶Unless otherwise stated, all operations can be carried out with the remote control. Always point the remote control directly at the player, making sure there are no obstructions in the path of the infrared beam.
When there are corresponding keys on the front panel of the player, they can also be used.