Philips MCD290 Connecting speakers, Antenna connection, Connecting TV, Using Video In jack Cvbs

Page 11

 

Connections

Step 2: Connecting speakers

FMAntenna

 

It is unnecessary to connect the FM pigtail

 

antenna since it is fixed to the main unit.

 

● Adjust the FM antenna for optimal FM stereo

 

reception.

English

Connect the speaker wires to the SPEAKERS terminals, right speaker to "RIGHT" and left speaker to "LEFT", coloured (marked) wire to "+" and black (unmarked) wire to "-". Fully insert the stripped portion of the speaker wire into the terminal as shown.

Notes:

–Ensure that the speaker cables are correctly connected. Improper connections may damage the system due to short-circuit.

–For optimal sound performance, use the supplied speakers.

–Do not connect more than one speaker to any one pair of +/- speaker terminals.

–Do not connect speakers with an impedance lower than the speakers supplied. Please refer to the SPECIFICATIONS section of this manual.

Step 3: Antenna connection

MW Antenna

Connect the supplied MW loop antenna to the "MW AERIAL" terminal. Adjust the position of the antenna for optimal reception.

●Position the antenna as far as possible from a TV, VCR or other radiation source.

Step 4: Connecting TV

IMPORTANT!

–You only need to make one video

connection from the following options, depending on the capabilities of your TV system.

–Connect the DVD system directly to the TV.

Using Video In jack (CVBS)

1Use the composite video cable (yellow) to connect the system's VIDEO jack to the video input jack (or labelled as A/V In,Video In, Composite or Baseband) on the TV set.

2To hear the sound of this DVD Player through your TV, use the audio cables (white/red-not supplied) to connect LINE OUT (L/R) jacks of the DVD Player to the corresponding AUDIO IN jacks on the TV.

11

Page 10 Page 12
Image 11
Page 10 Page 12
Contents DVD Micro Theatre Language Code H E a T H R E Page English IndexContents Tape Operation/Recording Clock/TimerSound and Volume Controls Radio ReceptionDiscs for playback FeaturesSupplied accessories General InformationEnvironmental information General Information/MaintenanceCare and safety information Type plate is located at the rear of the system ConnectionsPlacing speakers Antenna connection Connecting speakersConnecting TV Using Video In jack CvbsUsing an accessory RF modulator Using S-Video In jack Optional Connecting additional equipment Connecting the power cordControls on the system Controls on the remote controlControls Subtitle § Timer@ PLAY/PAUSE $ RepeatPreparations Inserting batteries into the remote controlOpen the battery compartment Using the remote control to operate SystemPAL Setting video preferenceSystem Menu NtscSubtitle Lang DVD only Setting language preferenceTo exit the menu Audio Lang DVD onlyAt any time, simply press Stop 9 to stop playback Playing discsIs not available on the current disc at the current time Disc Operations Special disc features Playback selection Playing MP3/JPEG DiscPlaying MP3 disc General operationPlayback with multi-angles Jpeg Special Jpeg featuresZoom picture Jpeg Slide show playback modes JpegTo return to the upper-level menu To change passwordSystem Menu Options Basic operationsNC-17 Rating explanationsKID Safe PG-R, RAdjusts the saturation level. Range Adjusts the brightness level. RangeAdjusts the contrast level. Range Adjusts the hue level. Range -6-+6Programming radio stations Tuning to radio stationsTuning to preset radio stations Radio ReceptionFor all versions Changing tuning grid not availableGeneral information on recording Tape Operation/RecordingTape playback One touch recording When recording is in progressPreparation for recording Synchro start CD recordingSleep timer setting Clock/TimerClock setting Timer settingDBB Dynamic Bass Boost Sound and Volume ControlsVolume control Sound ControlSpecifications Solution TroubleshootingProblem Check if the stripped speaker wire is clamped Glossary
Top Page Image Contents