Philips MCD290 manual Preparations, Inserting batteries into the remote control, Close the cover

Page 16

Press CLOCK to confirm the clock setting.

Notes:

– This system only supports 24-hour mode.

– The clock setting will be erased when the system is disconnected from the power supply.

– The system will exit clock setting mode if no button is pressed within 30 seconds.

6

Turn the VOLUME control on the front panel or press VOLUME +/- on the remote to set the minutes.

5

4 Press CLOCK again.

➜ The minute digits flash on the display screen.

Turn the VOLUME control on the front panel or press VOLUME +/- on the remote to set the hours.

3

Step 2: Setting the clock

1 Go to Standby mode.

2 Press and hold CLOCK on the front panel. ➜ “SET CLOCK” is displayed briefly.Then, the hour digits flash on the display screen.

English

Preparations

IMPORTANT!

–Make sure to complete the preparation procedures before operating the system.

Step 1: Inserting batteries into the remote control

1Open the battery compartment.

2Place two batteries (Type R06 or AA) in the compartment with the correct polarity as indicated by “+” and “–” symbols.

3Close the cover.

Using the remote control to operate the

system

1Point the remote control directly at the remote sensor (iR) on the front panel.

2 Select the source you wish to control by pressing one of the source select buttons on the remote control (for example DISC,TUNER).

3 Then select the desired function (for example 2;, í, ë).

CAUTION!

–Remove batteries if they are exhausted or will not be used for a long time.

–Do not use old and new or different types of batteries in combination.

–Batteries contain chemical substances, so they should be disposed of properly.

16

Image 16

Contents DVD Micro Theatre Language Code H E a T H R E Page Index EnglishContents Clock/Timer Sound and Volume ControlsRadio Reception Tape Operation/RecordingFeatures Supplied accessoriesGeneral Information Discs for playbackCare and safety information General Information/MaintenanceEnvironmental information Placing speakers ConnectionsType plate is located at the rear of the system Connecting speakers Connecting TVUsing Video In jack Cvbs Antenna connectionUsing an accessory RF modulator Using S-Video In jack Connecting the power cord Optional Connecting additional equipmentControls Controls on the remote controlControls on the system § Timer @ PLAY/PAUSE$ Repeat SubtitleInserting batteries into the remote control Open the battery compartmentUsing the remote control to operate System PreparationsSetting video preference System MenuNtsc PALSetting language preference To exit the menuAudio Lang DVD only Subtitle Lang DVD onlyIs not available on the current disc at the current time Playing discsAt any time, simply press Stop 9 to stop playback Disc Operations Special disc features Playing MP3/JPEG Disc Playing MP3 discGeneral operation Playback selectionSpecial Jpeg features Zoom picture JpegSlide show playback modes Jpeg Playback with multi-angles JpegTo change password System Menu OptionsBasic operations To return to the upper-level menuRating explanations KID SafePG-R, R NC-17Adjusts the brightness level. Range Adjusts the contrast level. RangeAdjusts the hue level. Range -6-+6 Adjusts the saturation level. RangeTuning to radio stations Tuning to preset radio stationsRadio Reception Programming radio stationsChanging tuning grid not available For all versionsTape playback Tape Operation/RecordingGeneral information on recording When recording is in progress Preparation for recordingSynchro start CD recording One touch recordingClock/Timer Clock settingTimer setting Sleep timer settingSound and Volume Controls Volume controlSound Control DBB Dynamic Bass BoostSpecifications Problem TroubleshootingSolution Check if the stripped speaker wire is clamped Glossary