Philips DCD778 quick start Setting the clock, Using the TV screen, Repeat to set the minute

Installation

Setting the clock

The time is displayed using the 12-hour clock.

1Check the set is switched to standby mode. (see Basic Functions, Switch on/to standby)

➜--:-- flashes by default if the clock is not set.

2On the set, press CLOCK on the set.

➜The hour digits start flashing (AM 12: 00 by default).

3Hold down or press TUNING ∞ / § ( + - ) on the set to set the hour. Release TUNING ∞ / § ( + - ) when you have reached the correct setting.

4Press CLOCK to confirm the setting. ➜ The minute digits start flashing.

5Repeat step 3 to set the minute.

6Press CLOCK to confirm the setting. ➜ The clock shows the set time.

Helpful hints:

–You may lose your clock setting when the power cord is disconnected or power failure occurs.

Using the TV screen

The set is equipped with a 8.5” TFT LCD monitor. You can watch TV on it. If you insert a disc, it will serve as an additional display for messages (e.g. PLAY, STOP), and information

stored on the disc.

2	1
	PUSH
	4
	3

1Press PUSH at the bottom of the set to release TV panel.

2Pull the down the panel (maximum 1100).

3Turn around the panel to find the screen.

4Adjust the screen to a suitable angle (maximum 2700).

E n g l i s h

13