Philips 34PT9421 /93 AV3/AV4 Digital High Definition input, Side connections, Camera or camcorder

AV3/AV4 Digital High Definition input

Y		RGB Y
	AUDIO		AUDIO
Pb	L	Pb	L
Pr	R	Pr	R
			VIDEO 2Fh
AV 4			480p/1080i
			AV 3

ININ

When you have a digital equipment with a 480p or 1080i output (e.g. a digital Set Top Box or Progressive DVD player), connect it to the AV3 or AV4 IN VIDEO 2Fh 480p/1080i input.

Connect the equipment with 2Fh RGB output to the RGB connector and to the L and R AUDIO jacks of AV3.

Connect the equipment with 2Fh YPbPr output to the Y, Pb and Pr jacks and to the L and R AUDIO jacks of AV4.

See also the manual of your High Definition equipment.

Note:This television is designed to accept high definition signal standards 1080i and 480p as specified by the Electronic Industries Association standard EIA770.3 as well as 2Fh-signal standards 576p and 1152i.

Digital devices from different manufacturers have the possibility of differing output standards which may cause difficulties for the television to properly display.

Warning: in case you notice scrolling images, wrong colours or no colour, no picture, or even combinations of these on your screen, check if the connections are done in the right way.

The AV3 input can not be used to connect a computer or any other VGA device.

Side connections

S•VIDEO

VIDEO

AUDIO

1 2 3

Camera or camcorder

&Connect your camera or camcorder to sockets at the right side of your TV.

éConnect the equipment to VIDEO 2 and AUDIO L 3 for mono equipment. For stereo equipment also connect AUDIO R 3.

S-Video quality with an S-VHS, Hi-8 or Digital camcorder is obtained by connecting the S-Video cables with the S-VIDEOinput 1 (instead of VIDEO 2) and AUDIO inputs 3.

Note: If you prefer, you can also connect the

camcorder to one of the TV’s rear AV IN jacks.

Headphone

&Insert the plug into the headphone socket L at the right side of the TV.

éPress ¬ on the remote control to switch off the internal loudspeakers of the TV.

The headphone impedance must be between 8 and 4000 Ohm. The headphone socket has a 3.5 mm jack.

In the Sound menu select Headphone volume to adjust the headphone volume. When the headphone is connected, the surround mode is always stereo.

Note:

When Dual screen/PIP is activated (see p. 14):

-if the main screen displays a TV channel picture, you hear the sound from the Dual screen/PIP picture through your headphone;

-if the main screen displays a picture from a peripheral equipment, you hear the sound from the main screen through your headphone.

Note: When using the S-VIDEOconnector do not connect any device to the video input.

20