Satellite Receiver

		AV 1
	Monitor	in	AV 2
	out	in	in
	VIDEO
		Y
	L / Mono
2	AUDIO	Pb	S-VIDEO
2	R	Pr

OUT

SAT

≈

SAT

&Connect the satellite antenna cable 1 to the satellite receiver’s SATELLITE IN jack.

éConnect the Video,Audio left and right (only for stereo equipment),AV cables 2 to the VIDEO, L and R AUDIO input AV1 in jacks.

If your satellite receiver has an S-VHS video jack:

For improved picture quality, connect an S-VHS video cable with the S-VIDEOinput instead of connecting the satellite receiver to the video jack of AV2 IN.

Satellite Receiver with a recorder

	Monitor	AV 1	AV 2
	Monitor	AV 1	in
	out	in	in
	VIDEO	Y	CABLE
		Y
	L / Mono
5	AUDIO	Pb	S-VIDEO
5	R		3
75		Pr

&Connect your satellite receiver as described above.

éConnect the RF Antenna or Cable TV cable 1 to the RF IN socket of your recorder.

“Connect another RF cable 2 from the output of your recorder to the TV’s 75 ø x jack.

‘Connect the satellite antenna cable 3 to the satellite receiver’s SATELLITE IN jack.

OUT		SAT
IN		IN
IN		OUT
OUT
IN	4	≈
IN		≈

(Connect the AV cables 4 to the satellite receiver’s AV OUT jacks and to the VCR’s AV IN jacks.

§ Connect the recorder’s

jacks 5 to the TV’s

REC

SAT

AV OUT

AV2 IN jacks.

DVD player or other accessory digital source equipment

Monitor	AV 1	AV 2
out	in	in
VIDEO
	Y
L
AUDIO	Pb	S-VIDEO
R	Pr
	Pr

Equipment with AV connectors only

&Connect the video cables to the equipment’s AV OUT jacks and to the TV’s AV1 or AV2 IN jacks.

éConnect the audio cables to the equipment’s AUDIO L and R jacks and to the L AUDIO and R AUDIO AV1 or AV2 jacks on the TV. (According to where you connected the video cables, to AV1 or

AV2.)

Equipment with an S-VIDEOconnector

&Connect an S-video cable the AV2 S-VIDEOinput.

Note: When using the s-video connector do not connect any device to the video input.

éConnect the audio cables to the equipment’s AUDIO L and R jacks and to the L AUDIO and R AUDIO AV2 jacks on the TV.

With Component Video Output Connectors

&Connect the cables of your YPbPr equipment to the YPbPr input AV1 IN sockets on the TV.

Note: When using the YPbPr sockets do not connect any device to the video input of AV1.

The YPbPr sockets on the TV are compatible with 480i (interlaced, 1 Fh) output signals only, not 480p (progressive scan, 2 Fh).

éConnect the Audio left and right (only for stereo devices) cables to the AUDIO L and R input of AV1. Warning: Never connect a signal to the Y-input and video-input at the same time. This may cause picture distortion!

Equipment with Progressive scan output (480p, 576p or 1080i 2 Fh)

Connect the equipment to the AV3 or AV4 IN jacks on the TV.

See AV3 or AV4 Digital HD input, next page.

Note:The labels for the component video sockets may differ depending on the DVD player. Although the abbreviations may vary, the letters B and R stand for the blue and red component signals, respectively, and Y indicates the luminance signal. Refer to the DVD player’s instructions for use for definitions and connection details.