Activate Parental Control

arental control allows you to block out any channels. A channel blocked by the Parental Control cannot be viewed until a correct password is used to unblock the channel for viewing. Parental control is defaulted without password protection. The first time you use the TV, create a password to activate Parental Control.

Follow these steps for Digital Mode and Analog Mode.

Press MENU button on the remote control to display onscreen menu.

Press CURSOR or to scroll through the onscreen menu until you see Parental Control highlighted. Press CURSOR or to display the PARENTAL CONTROL menu.

Press CURSOR or to scroll through PARENTAL CONTROL features until you see Lock highlighted. Press CURSOR or to check. Then the PASSWORD menu appears to prompt you to create password.

Press CURSOR or followed by the NUMERIC buttons on the remote control to enter a four-digit password. You are required to input twice so as to confirm the password.

NOTE: Remember this code which you have set. You can use this code to access the Parental Control features in both Digital and Analog mode.

	,,	,,
Lock option is a		master switch for activating Parental

Control. Parental Control cannot take effect unless the lock option is checked.

Once a password is set, the Parental Control menu and Time menu are protected. That is, every time you want to enter Parental Control menu or Time menu,


you are prompted to enter password. If you enter a			,,
wrong password,	,,	Incorrect Password. Try again.

will appear at the help line. Only with a correct pass- word, you have access to these two menus.

MAIN MENU

Exit

Sound

Picture

Setup

Parental Control

Time

PARENTAL CONTROL

Go Back

Lock

Settings

Change Passwd.

Par. Controls are not active!

PASSWORD

Go Back

Password ----

Enter Password

PARENTAL CONTROL

Go Back

Lock

Settings

Change Passwd.

Par. Controls are active!

NUMERIC

HELPFUL HINTS

If you forget the password, you can reset it with key combinations:

Put the TV to Standby mode first, then press the VOL- button on the front panel and the Clear button on the remote control at the same time and hold them for 5 seconds.