Philips FPF42C128135UA-52 technical specifications Fault Fault status Contents

EN 24 5. FHP PDP Service Modes, Error Codes, and Fault Finding

NO	Fault	Fault status
	contents
1	Entire screen	After momentarily going on, the
	does not	screen becomes black
	light.	immediately or after a few
		seconds (main power is turned
		off.)

Suspected	Analysis procedure
fault location	and measure
X-SUS	Refer to
Y-SUS	“Entire screen
PSU	does not light”
Panel chassis
LOGIC
ABUSL
ABUSR

2Screen lights dimly even on the back screen.

3	Vertical line	Single vertical line (of different
		color)

4Vertical line from the middle of effective scan area (vertical line of different color)

5	Vertical bar	Bar width of 1/7 of horizontal size
		or in multiples of 1/7, is displayed.
		Abnormal display

LOGIC	Replace the LOGIC
	board, following the
	“Logic Board
	Exchange” procedure
Panel chassis	Refer to
LOGIC	“Vertical line/bar”

Panel chassis	Replace panel
	chassis

Panel chassis	Refer to
ABUS-L	“Vertical line/bar”
ABUS-R
LOGIC
Above boards
are connected.

6

7Horizontal line

8

Bar width of 3/7 or 4/7 of the	ABUS-L
screen width, is displayed.	ABUS-R
Abnormal display (vertical line of	LOGIC
different color)	Above boards
	are connected.
Single horizontal line (no light) or	Panel chassis	Replace panel
single horizontal line does not	X-SUS	chassis
light among the effective scanning	Y-SUS
area.	ABUS-L
Single horizontal line does not	ABUS-R
light.
Every other line (no light) in entire	X-SUS	Replace
screen	Y-SUS	X-SUS, Y-SUS
	ABUS-L
	ABUS-R

G_16400_023.eps 280706

Figure 5-15 Fault symptom overview (1/2)