EN 6 |
| 3. |
| FHP PDP | Directions for Use |
3. Directions for Use
Not applicable.
4. Mechanical Instructions
Notes:
•Figures below can deviate from the actual situation, due to different set executions.
•For more detailed instructions regarding the (dis)assembly of the TV chassis that hold these PDPs, read the corresponding TV Service Manual.
4.1Board Swap Instructions
4.1.1General
Before dismounting panels read notes below!
Caution when removing circuit board!
When removing the circuit board after the main power is turned on/off, wait for at least one minute before starting to remove the circuit board.
If the circuit board removal is started immediately after turning off the main power, it can result in electric shock or damage to the circuit due to residual electric charge.
Caution on handling the FPC connector!
To release the black lock lever of the connector, flip it up gently in the middle with the nail of the thumb or forefinger, from the side with the cable.
Never pinch the lock lever with fingers or tools. Doing so might damage the lock lever.
E_14580_025.eps |
071005 |
Figure 4-1 Handling the FPC connector
5. Release the white
4.1.2X-SUS and X-BUS Circuit Boards
5 |
5 |
3 |
2 |
4 |
2 |
2 |
5 |
3 |
1 |
4 |
5 |
G_16400_007.eps |
300706 |
Figure 4-2 X-BUS and X-SUS board removal (1/2)
X-BUS
X-SUS
G_16400_008.eps 180706
Figure 4-3 X-BUS and X-SUS board removal (2/2)
Remove the circuit boards by following the steps below. To install the circuit boards, reverse the removal procedure.
1.Release the lock of the FPC connector [1] and unplug the signal cable.
2.Unplug the connectors [2].
3.Unplug the 4 XFPC’s [3] on the
4.Remove the fixing screws [4].
and from the top and bottom of the