Mechanical Instructions | FHP PDP |
| 4. |
| EN 7 |
6. Remove the
Make sure that you do not touch the heat sink when removing the
4.1.3 | Threaded bush for |
|
4 |
Adhesive side should be against the IC of
5 |
3 |
2 |
Radiation Plate
4
1
G_16400_010.eps 310706
Figure 4-6 Radiation plate position
G_16400_009.eps 300706
Figure 4-4 Y-SUS board removal (1/2)
Y-SUS
G_16400_011.eps 180706
Figure 4-5 Y-SUS board removal (2/2)
Remove the circuit board by following the steps below. To install the circuit board, reverse the removal procedure.
1.Release the lock of the FPC connector [1] and unplug the signal cable.
2.Unplug the connector [2].
3.Remove the fixing screws [3].
4.Release the white
5.Pull out the
6.Remove the
Make sure that you do not touch the heat sink when removing the
Note: Make sure the radiation plate is positioned correctly. It is located underneath the upper SDM, and the threaded bush should sit in the hole of the radiation plate.