Important instructions for the HDD, Alaser

Warnings/information

Important

ACaution! Visible and invisible laser radiation. If the cover is open, do not look at the beam.

Because of the risk of eye injuries, only qualified service engineers should open the device and carry out maintenance or repair work.

ALASER

Typ: Semiconductor lasers InGaAlP (DVD), AlGaAs(CD)

Wavelength: 660nm (DVD), 780nm (CD)

Output power (outside the lens): 20mW (DVD+RW write), 0.8mW (DVD read), 0.3mW (CD read).

Beam divergence: 82 degrees (DVD), 54 degrees (CD)

ADanger. High voltage! Do not open.

Do not insert objects into the ventilation slots and fan openings!

You run the risk of getting an electric shock.

AThe device does not contain any user-serviceable parts. Please leave all maintenance work to qualified personnel.

AThere are some components in the DVD recorder that keep running as long as the recorder is connected to the power supply. To switch off the DVD recorder completely, you must unplug it from the power supply.

AIf you disconnect the DVD recorder from the mains, make sure to take the plug out of the wall socket and not just remove the connector from the 4MAINS J socket at the back of the unit. Children playing near the device could suffer injuries at the free end of the cable.

AMake sure that air can circulate freely through the ventilation slots on the side and the fan opening at the back of the device to avoid overheating. The device should be placed on a firm surface.

ADo not insert any objects into the openings or ventilation slots of the device.

CThese operating instructions have been printed on non-polluting paper.

CPlease dispose of old batteries safely.

CPlease take the packaging to your local recycling center.

CThis electronic equipment contains several materials that can be recycled. If you are disposing of an old device, please take it to a recycling center.

BDo not switch on the device immediately after transport from a cold to a warm room or vice versa, or under conditions of extreme humidity.

Wait at least three hours after transporting the device. The DVD recorder needs this time to acclimate to its new environment (temperature, relative humidity, etc.).

BWhen installing the recorder in a cupboard, ensure there is a gap of approximately 5 cm (2 inch) around the recorder to enable air to circulate freely and prevent overheating.

BMake sure that no objects or liquids enter into the DVD recorder. Do not place vases or the like on the DVD recorder. If you spill liquid into the recorder, immediately disconnect it from the power supply and call after-sales service for advice.

BKeep the DVD recorder away from radiators and other heat sources and protect it from direct sunlight.

BDo not place any combustible objects on the device (candles, etc.).

Important instructions for the HDD

The built-in HDD of this DVD recorder is sensitive to shocks, temperature fluctuations, and vibrations.

DO NOT MOVE THE SET WHEN SWITCHED ON !

because the HDD is always running and can be damaged.

Please observe the following precautions:

BAvoid shocks or vibrations

BDo not cover the ventilation openings of the cooling fan

BDo not operate the device under high temperatures, and do not expose it to temperature fluctuations

BDo not pull the mains plug from the wall outlet before the device is switched off using STANDBY m 2 .

BBefore bringing the device to a workshop for repair, store all important data of the HDD on a DVD+RW, DVD+R. See 'The archive function'.

The workshop will not assume any liability for the loss of the stored data.

BPhilips will not assume any liability for damage or loss of stored data.