Philips HDTV user manual Command Parameters, Cmd Data Details

User Manual BDH5011

Notes:

•To connect a PC to the display’s RS-232 port, you must use a straight-through RS-232 cable where pins 2 (RX) and 3 (TX) are not reversed at one end.

•If there is no data to be sent, then it is not necessary to send the parameter signal.

•If multiple commands are transmitted, make sure to wait for the response for the first command to come from the display before sending the next command. Normally the sent data byte will be returned as an answer. In case of an error the next signals will be returned:

RESPONSE: 70h = MODE ERROR 71h = TEM ERROR

72h = FORMAT ERROR

Command Parameters

These remote control commands are available to send to the display using RS-232.

Item	Cmd	Data	Details
Read	80	81-A7	Reads the
			displays current
			settings for
			command 81
			thru A7
Volume	81	01-64H	Set between 01-64H
Power On/Off	83	00-01	00=Off, 01=On
Brightness	85	01-64H
Contrast	86	01-64H
V-Size	87	01-64H
V-Position	88	01-64H
H-Size	89	01-64H
H-Position	8A	01-64H
Color	8E	01-64H
Tint	8F	01-64H
Sharpness	90	01-64H
Input Select	91	00-07	00=TV, 01=AV1,
			02=AV2, 03=AV3,
			04=Component 1
			05=Component 2
			06=RGB,
			07=DVI
Recall	92	00	00=Initiate a recall
Mute On/Off	95	00-01	00=Off 01=On
PanelKey Lock	96	00-01	00=Off 01=On
Language	97	00-02	00=English,
			01=French,
			02=Spanish
Color Temp	98	00-03	00=High, 01=Mid,
			02=Low,
			03=6500D
Bass	9A	01-64H
Treble	9B	01-64H
Balance	9C	01-64H

20